From mboxrd@z Thu Jan 1 00:00:00 1970 From: Greg Stark Date: Thu, 10 Jun 2004 16:23:11 +0000 Subject: [LARTC] Re: Shaping incoming traffic on the other interface Message-Id: <87u0xjtma8.fsf@stark.xeocode.com> List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: lartc@vger.kernel.org Matteo Brusa writes: > Hi, > I have a typical configuration for my firewall/gateway box: single network > card, with a pppoe connection to the DSL modem. > I'm already successfully shaping the uplink (how come that the > wondershaper.htb doesn't use the ceil parameter? It should implement bandwidth > borrowing!) but i found the ingress policy a little bit rough. > I'd like to keep the traffic categories i have in the uplink: ssh, web and batch. > The goal is to discard packets of the lowest class first, then the middle, and so on. > I've implemented a simmetrical downlink version of the uplink shaping on eth0, > the other interface. However, i get this error (warning?) in the log: > pppoe[29606]: send (sendPacket): No buffer space available Hm, I just did exactly the same thing here. I don't see this. What do your filters look like? I do see HTB: dequeue bug (8), report it please ! which I think is because i have too low burst/cburst settings. My settings currently look like: tc class add dev $DEV parent 1: classid 1:1 htb rate ${BW}kbit burst 8k cburst 8k tc class add dev $DEV parent 1:1 classid 1:10 htb rate ${BW80}kbit ceil ${BW}kbit burst 8k cburst 8k prio 1 tc class add dev $DEV parent 1:1 classid 1:20 htb rate ${BW10}kbit ceil ${BW}kbit burst 4k cburst 1k prio 2 tc class add dev $DEV parent 1:1 classid 1:30 htb rate ${BW10}kbit ceil ${BW}kbit burst 2k cburst 1k prio 3 (where ${BWxx} = xx% of the total bandwidth I want on that link) -- greg _______________________________________________ LARTC mailing list / LARTC@mailman.ds9a.nl http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/