Re: [V3, 1/4] Documentation: dt-bindings: phy: Document the Synopsys MIPI DPHY Rx bindings

[Laurent Pinchart <laurent.pinchart@ideasonboard.com>]

Hi Luis,

Thank you for the patch.

On Friday, 19 October 2018 15:52:23 EET Luis Oliveira wrote:
> Add device-tree bindings documentation for SNPS DesignWare MIPI D-PHY in
> RX mode.
> 
> Signed-off-by: Luis Oliveira <lolivei@synopsys.com>
> ---
> Changelog
> v2-V3
> - removed gpios reference - it was for a separated driver
> - changed address to show complete address
> 
>  .../devicetree/bindings/phy/snps,dphy-rx.txt       | 28 +++++++++++++++++++
>  1 file changed, 28 insertions(+)
>  create mode 100644 Documentation/devicetree/bindings/phy/snps,dphy-rx.txt
> 
> diff --git a/Documentation/devicetree/bindings/phy/snps,dphy-rx.txt
> b/Documentation/devicetree/bindings/phy/snps,dphy-rx.txt new file mode
> 100644
> index 0000000..03d17ab
> --- /dev/null
> +++ b/Documentation/devicetree/bindings/phy/snps,dphy-rx.txt
> @@ -0,0 +1,28 @@
> +Synopsys DesignWare MIPI Rx D-PHY block details
> +
> +Description
> +-----------
> +
> +The Synopsys MIPI D-PHY controller supports MIPI-DPHY in receiver mode.
> +Please refer to phy-bindings.txt for more information.
> +
> +Required properties:
> +- compatible		: Shall be "snps,dphy-rx".
> +- #phy-cells		: Must be 1.
> +- snps,dphy-frequency	: Output frequency of the D-PHY.

You replied to my review of v2 that you would remove this property. Is this an 
oversight ?

> +- snps,dphy-te-len	: Size of the communication interface (8 bits->8 or
> 12bits->12).
> +- reg			: Physical base address and size of the device memory mapped
> +		 	  registers;

Please document the ranges.

> +Example:
> +
> +	mipi_dphy_rx1: dphy@d00003040 {
> +		compatible = "snps,dphy-rx";
> +		#phy-cells = <1>;
> +		snps,dphy-frequency = <300000>;
> +		snps,dphy-te-len = <12>;
> +		reg = < 0xd0003040 0x20
> +			0xd0008000 0x100
> +			0xd0009000 0x100>;
> +	};
> +

-- 
Regards,

Laurent Pinchart