Re: [PATCH v1 7/9] serial: qcom-geni: move clock-rate logic to separate function

[Jiri Slaby <jirislaby@kernel.org>]

On 10. 04. 25, 19:40, Praveen Talari wrote:
> Facilitates future modifications within the new function,
> leading to better readability and maintainability of the code.
> 
> Move the code that handles the actual logic of clock-rate
> calculations to a separate function geni_serial_set_rate()
> which enhances code readability.
> 
> Signed-off-by: Praveen Talari <quic_ptalari@quicinc.com>
> ---
>   drivers/tty/serial/qcom_geni_serial.c | 56 +++++++++++++++++----------
>   1 file changed, 36 insertions(+), 20 deletions(-)
> 
> diff --git a/drivers/tty/serial/qcom_geni_serial.c b/drivers/tty/serial/qcom_geni_serial.c
> index e341f5090ecc..25d16ac3f406 100644
> --- a/drivers/tty/serial/qcom_geni_serial.c
> +++ b/drivers/tty/serial/qcom_geni_serial.c
...
> @@ -1323,6 +1310,37 @@ static void qcom_geni_serial_set_termios(struct uart_port *uport,
>   	port->se.icc_paths[CPU_TO_GENI].avg_bw = Bps_to_icc(baud);
>   	geni_icc_set_bw(&port->se);
>   
> +	writel(ser_clk_cfg, uport->membase + GENI_SER_M_CLK_CFG);
> +	writel(ser_clk_cfg, uport->membase + GENI_SER_S_CLK_CFG);
> +	return 0;

Did this pass checkpatch?

> +}
> +
> +static void qcom_geni_serial_set_termios(struct uart_port *uport,
> +					 struct ktermios *termios,
> +					 const struct ktermios *old)
> +{
> +	struct qcom_geni_serial_port *port = to_dev_port(uport);
> +	unsigned int baud;
> +	unsigned long timeout;
> +	u32 bits_per_char;
> +	u32 tx_trans_cfg;
> +	u32 tx_parity_cfg;
> +	u32 rx_trans_cfg;
> +	u32 rx_parity_cfg;
> +	u32 stop_bit_len;
> +	int ret = 0;
> +
> +	/* baud rate */
> +	baud = uart_get_baud_rate(uport, termios, old, 300, 4000000);
> +
> +	ret = geni_serial_set_rate(uport, baud);
> +	if (ret) {
> +		dev_err(port->se.dev,
> +			"%s: Failed to set  baud: %u  ret: %d\n",

Why the doubled spaces?

> +			__func__, baud, ret);
> +		return;
> +	}
> +
>   	/* parity */
>   	tx_trans_cfg = readl(uport->membase + SE_UART_TX_TRANS_CFG);
>   	tx_parity_cfg = readl(uport->membase + SE_UART_TX_PARITY_CFG);

thanks,
-- 
js
suse labs