From: Paul Blazejowski <diffie@gmail.com>
To: Andrew Morton <akpm@osdl.org>
Cc: LKML <linux-kernel@vger.kernel.org>
Subject: Re: 2.6.9-rc1-mm4
Date: Thu, 9 Sep 2004 00:42:13 -0400 [thread overview]
Message-ID: <9dda3492040908214277f3d454@mail.gmail.com> (raw)
Andrew,
IT8212 driver fails to recognize RAID0 setup. The driver is built in
as module (it8212).
The drives are WDC 120gigers on primary channel as master/slave
configured for RAID0.
>From dmesg:
IT8212: IDE controller at PCI slot 0000:01:0c.0
ACPI: PCI Interrupt Link [APC2] enabled at IRQ 17
ACPI: PCI interrupt 0000:01:0c.0[A] -> GSI 17 (level, high) -> IRQ 17
IT8212: chipset revision 16
IT8212: 100% native mode on irq 17
ide2: BM-DMA at 0x9800-0x9807, BIOS settings: hde:DMA, hdf:pio
it8212: controller in RAID mode.
ide3: BM-DMA at 0x9808-0x980f, BIOS settings: hdg:pio, hdh:pio
Probing IDE interface ide2...
hde: Integrated Technology Express Inc, ATA DISK drive
ide2 at 0x8810-0x8817,0x8c02 on irq 17
hde: max request size: 128KiB
hde: 0 sectors (0 MB), CHS=0/0/0
hde: cache flushes not supported
hde: INVALID GEOMETRY: 0 PHYSICAL HEADS?
Probing IDE interface ide3...
lsmod shows:
it8212 6336 0 [permanent]
lspci -v:
01:0c.0 RAID bus controller: Integrated Technology Express, Inc.
IT/ITE8212 Dual channel ATA RAID controller (PCI version seems to be
IT8212, embedded seems (rev 10)
Subsystem: Integrated Technology Express, Inc.: Unknown device 0001
Flags: bus master, 66Mhz, medium devsel, latency 0, IRQ 17
I/O ports at 8810 [size=8]
I/O ports at 8c00 [size=4]
I/O ports at 9010 [size=8]
I/O ports at 9400 [size=4]
I/O ports at 9800 [size=16]
Expansion ROM at <unassigned> [disabled] [size=128K]
Capabilities: [80] Power Management version 2
The board is Gigabyte GA-7NNXP.
Under mm3 kernel, RAID0 was working when using the now dropped iteraid driver.
Paul
--
FreeBSD the Power to Serve!
next reply other threads:[~2004-09-09 4:42 UTC|newest]
Thread overview: 36+ messages / expand[flat|nested] mbox.gz Atom feed top
2004-09-09 4:42 Paul Blazejowski [this message]
2004-09-09 4:44 ` 2.6.9-rc1-mm4 Andrew Morton
2004-09-09 13:37 ` 2.6.9-rc1-mm4 Alan Cox
-- strict thread matches above, loose matches on Subject: below --
2004-09-08 15:43 2.6.9-rc1-mm4 Sid Boyce
2004-09-08 7:29 2.6.9-rc1-mm4 Sid Boyce
2004-09-07 16:45 2.6.9-rc1-mm4 Martin J. Bligh
2004-09-07 20:13 ` 2.6.9-rc1-mm4 Sam Ravnborg
2004-09-07 21:17 ` 2.6.9-rc1-mm4 Andrew Morton
2004-09-09 14:27 ` 2.6.9-rc1-mm4 Martin J. Bligh
2004-09-09 17:57 ` 2.6.9-rc1-mm4 Nick Piggin
2004-09-07 21:29 ` 2.6.9-rc1-mm4 Sam Ravnborg
2004-09-07 9:08 2.6.9-rc1-mm4 Andrew Morton
2004-09-07 11:59 ` 2.6.9-rc1-mm4 Terje Kvernes
2004-09-07 14:24 ` 2.6.9-rc1-mm4 Kasper Sandberg
2004-09-07 14:32 ` 2.6.9-rc1-mm4 Terje Kvernes
2004-09-07 17:04 ` 2.6.9-rc1-mm4 Francois Romieu
2004-09-07 18:30 ` 2.6.9-rc1-mm4 Terje Kvernes
2004-09-07 12:05 ` 2.6.9-rc1-mm4 Terje Kvernes
2004-09-07 12:21 ` 2.6.9-rc1-mm4 Simon Derr
2004-09-08 8:47 ` 2.6.9-rc1-mm4 Andrew Morton
2004-09-08 8:54 ` 2.6.9-rc1-mm4 Simon Derr
2004-09-08 9:37 ` 2.6.9-rc1-mm4 David Howells
2004-09-07 14:31 ` 2.6.9-rc1-mm4 Norberto Bensa
2004-09-07 15:45 ` 2.6.9-rc1-mm4 Zwane Mwaikambo
2004-09-07 16:46 ` 2.6.9-rc1-mm4 Danny ter Haar
2004-09-07 20:01 ` 2.6.9-rc1-mm4 Lorenzo Allegrucci
2004-09-07 20:23 ` 2.6.9-rc1-mm4 Nathan Bryant
2004-09-07 21:07 ` 2.6.9-rc1-mm4 Bjorn Helgaas
2004-09-08 8:15 ` 2.6.9-rc1-mm4 Lorenzo Allegrucci
2004-09-08 13:00 ` 2.6.9-rc1-mm4 William Lee Irwin III
2004-09-08 13:10 ` 2.6.9-rc1-mm4 David Howells
2004-09-08 20:16 ` 2.6.9-rc1-mm4 Nathan Lynch
2004-09-09 2:01 ` 2.6.9-rc1-mm4 William Lee Irwin III
2004-09-09 2:30 ` 2.6.9-rc1-mm4 William Lee Irwin III
2004-09-09 18:04 ` 2.6.9-rc1-mm4 Pasi Savolainen
2004-09-09 19:33 ` 2.6.9-rc1-mm4 Pasi Savolainen
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=9dda3492040908214277f3d454@mail.gmail.com \
--to=diffie@gmail.com \
--cc=akpm@osdl.org \
--cc=linux-kernel@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.