From: Philip Stewart <philip.stewart.public@gmail.com>
To: iwd@lists.01.org
Subject: DEL_INTERFACE and CMD_SET_CQM failed; Could not register frame watch type 00d0: -95
Date: Sun, 18 Apr 2021 18:21:47 +0100 [thread overview]
Message-ID: <B8SRRQ.IJ5TG5C88S3O3@gmail.com> (raw)
[-- Attachment #1: Type: text/plain, Size: 4493 bytes --]
Hello,
I've recently switched from NetworkManager and wpasupplicant to
systemd-networkd and iwd. Whilst everything appears to be working fine,
I'm curious about some failures reported by iwd:
Apr 18 15:10:32 systemd[1]: Starting Wireless service...
Apr 18 15:10:33 iwd[661]: Wireless daemon version 1.12
Apr 18 15:10:33 systemd[1]: Started Wireless service.
Apr 18 15:10:33 iwd[661]: station: Network configuration is disabled.
Apr 18 15:10:33 iwd[661]: Wiphy: 0, Name: phy0
Apr 18 15:10:33 iwd[661]: Permanent Address: 00:00:00:00:00:00
Apr 18 15:10:33 iwd[661]: Bands: 2.4 GHz 5 GHz
Apr 18 15:10:33 iwd[661]: Ciphers: CCMP TKIP BIP
Apr 18 15:10:33 iwd[661]: Supported iftypes: ad-hoc station
Apr 18 15:10:33 iwd[661]: DEL_INTERFACE failed: Operation not supported
Apr 18 15:10:33 iwd[661]: Could not register frame watch type 00d0: -95
Apr 18 15:10:33 iwd[661]: Could not register frame watch type 00d0: -95
Apr 18 15:10:33 iwd[661]: Could not register frame watch type 00d0: -95
Apr 18 15:10:33 iwd[661]: Could not register frame watch type 00d0: -95
Apr 18 15:10:33 iwd[661]: CMD_SET_CQM failed: Operation not supported
Apr 18 15:10:33 iwd[661]: Could not register frame watch type 00d0: -95
Apr 18 15:10:33 iwd[661]: Could not register frame watch type 00d0: -95
Further, I note that in the output of 'networkctl status wlan0', the
WiFi access point MAC address is reported as 00:00:00:00:00:00 and I'm
wondering if this is a consequence of these failures and if there is
anything I can do about it?
Kind regards,
Phil
# lspci -vv -d 14e4:
03:00.0 Network controller: Broadcom Inc. and subsidiaries BCM4322
802.11a/b/g/n Wireless LAN Controller (rev 01)
Subsystem: Apple Inc. AirPort Extreme
Control: I/O- Mem+ BusMaster+ SpecCycle- MemWINV- VGASnoop- ParErr-
Stepping- SERR- FastB2B- DisINTx-
Status: Cap+ 66MHz- UDF- FastB2B- ParErr- DEVSEL=fast >TAbort-
<TAbort- <MAbort- >SERR- <PERR- INTx-
Latency: 0, Cache Line Size: 256 bytes
Interrupt: pin A routed to IRQ 20
Region 0: Memory@d3200000 (64-bit, non-prefetchable) [size=16K]
Capabilities: [40] Power Management version 3
Flags: PMEClk- DSI- D1+ D2+ AuxCurrent=0mA
PME(D0+,D1-,D2-,D3hot+,D3cold+)
Status: D0 NoSoftRst+ PME-Enable- DSel=0 DScale=2 PME-
Capabilities: [58] Vendor Specific Information: Len=78 <?>
Capabilities: [e8] MSI: Enable- Count=1/1 Maskable- 64bit+
Address: 0000000000000000 Data: 0000
Capabilities: [d0] Express (v1) Endpoint, MSI 00
DevCap: MaxPayload 128 bytes, PhantFunc 0, Latency L0s <4us, L1
unlimited
ExtTag+ AttnBtn- AttnInd- PwrInd- RBE+ FLReset- SlotPowerLimit 0.000W
DevCtl: CorrErr- NonFatalErr- FatalErr- UnsupReq-
RlxdOrd- ExtTag+ PhantFunc- AuxPwr- NoSnoop-
MaxPayload 128 bytes, MaxReadReq 128 bytes
DevSta: CorrErr- NonFatalErr- FatalErr- UnsupReq- AuxPwr- TransPend-
LnkCap: Port #0, Speed 2.5GT/s, Width x1, ASPM L0s L1, Exit Latency
L0s <4us, L1 <64us
ClockPM+ Surprise- LLActRep- BwNot- ASPMOptComp-
LnkCtl: ASPM L0s L1 Enabled; RCB 64 bytes, Disabled- CommClk+
ExtSynch- ClockPM+ AutWidDis- BWInt- AutBWInt-
LnkSta: Speed 2.5GT/s (ok), Width x1 (ok)
TrErr- Train- SlotClk+ DLActive- BWMgmt- ABWMgmt-
Capabilities: [100 v1] Advanced Error Reporting
UESta: DLP- SDES- TLP- FCP- CmpltTO- CmpltAbrt- UnxCmplt- RxOF-
MalfTLP- ECRC- UnsupReq- ACSViol-
UEMsk: DLP- SDES- TLP- FCP- CmpltTO- CmpltAbrt- UnxCmplt- RxOF-
MalfTLP- ECRC- UnsupReq- ACSViol-
UESvrt: DLP+ SDES- TLP- FCP+ CmpltTO- CmpltAbrt- UnxCmplt- RxOF+
MalfTLP+ ECRC- UnsupReq- ACSViol-
CESta: RxErr- BadTLP- BadDLLP- Rollover- Timeout- AdvNonFatalErr-
CEMsk: RxErr- BadTLP- BadDLLP- Rollover- Timeout- AdvNonFatalErr+
AERCap: First Error Pointer: 00, ECRCGenCap+ ECRCGenEn- ECRCChkCap+
ECRCChkEn-
MultHdrRecCap- MultHdrRecEn- TLPPfxPres- HdrLogCap-
HeaderLog: 00000000 00000000 00000000 00000000
Capabilities: [13c v1] Virtual Channel
Caps: LPEVC=0 RefClk=100ns PATEntryBits=1
Arb: Fixed- WRR32- WRR64- WRR128-
Ctrl: ArbSelect=Fixed
Status: InProgress-
VC0: Caps: PATOffset=00 MaxTimeSlots=1 RejSnoopTrans-
Arb: Fixed- WRR32- WRR64- WRR128- TWRR128- WRR256-
Ctrl: Enable+ ID=0 ArbSelect=Fixed TC/VC=ff
Status: NegoPending- InProgress-
Capabilities: [160 v1] Device Serial Number xx-xx-xx-xx-xx-xx-xx-xx
Capabilities: [16c v1] Power Budgeting <?>
Kernel driver in use: wl
Kernel modules: ssb, wl
next reply other threads:[~2021-04-18 17:21 UTC|newest]
Thread overview: 9+ messages / expand[flat|nested] mbox.gz Atom feed top
2021-04-18 17:21 Philip Stewart [this message]
2021-04-19 16:07 ` DEL_INTERFACE and CMD_SET_CQM failed; Could not register frame watch type 00d0: -95 James Prestwood
2021-04-19 18:16 ` Philip Stewart
2021-04-19 19:06 ` James Prestwood
2021-04-19 19:58 ` Philip Stewart
2021-04-19 20:10 ` James Prestwood
2021-04-19 20:41 ` Philip Stewart
2021-04-19 20:55 ` Denis Kenzior
2021-04-19 21:25 ` Philip Stewart
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=B8SRRQ.IJ5TG5C88S3O3@gmail.com \
--to=philip.stewart.public@gmail.com \
--cc=iwd@lists.01.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.