From mboxrd@z Thu Jan 1 00:00:00 1970 Date: Wed, 21 Mar 2012 00:46:44 -0400 From: Glen Wernersbach Message-ID: In-Reply-To: <4F68EA11.30109@domain.hid> Mime-version: 1.0 Content-type: text/plain; charset="ISO-8859-1" Content-transfer-encoding: quoted-printable Subject: Re: [Xenomai-help] Linux Serial Does not work with CONFIG_XENO_OPT_PERVASIVE enabled List-Id: Help regarding installation and common use of Xenomai List-Unsubscribe: , List-Archive: List-Post: List-Help: List-Subscribe: , To: Gilles Chanteperdrix Cc: "xenomai@xenomai.org" I am going to start trying to see if I can figure out what is not getting set. By the way. This board also has 4 other serial ports on a 8250.c driver. It also fails under the xeno build. On 3/20/12 4:35 PM, "Gilles Chanteperdrix" wrote: > On 03/20/2012 09:19 PM, Glen Wernersbach wrote: >> I actually think in is in the settings because if run just the setup par= t of >> the code without reading and writing, on the kernel that works my activi= ty >> LED turns off.=20 >>=20 >> On the xeno kernel the LED never changes. >=20 > I actually think that CONFIG_XENO_OPT_PERVASIVE does not make any > difference which could cause a difference of hardware behaviour. So, it > must be another option triggered by this config change. So, if you want > us to help you, please post the .configs. >=20 --=20 Glen Wernersbach President & CTO Jetsoft Development Co. 629 Old St Rt. 74 =AD Suite 210 Cincinnati, Oh 45244 Custom Programming Web Site: www.jetsoftdev.com Retail Products Web Site: www.scanhelp.com Phone: 513-528-6660 Fax: 513-528-3470 Cell 513-240-9929 ---- Partner for Software Technology Jacobs Automation 2365 Progress Drive Hebron, KY 41048=20 (513) 297-7550 ---- "Support Dyslexia Research"