From mboxrd@z Thu Jan 1 00:00:00 1970 Date: Mon, 26 Mar 2012 01:27:18 -0400 From: Glen Wernersbach Message-ID: In-Reply-To: <4F6986AD.9050201@domain.hid> Mime-version: 1.0 Content-type: text/plain; charset="ISO-8859-1" Content-transfer-encoding: quoted-printable Subject: Re: [Xenomai-help] Linux Serial Does not work with CONFIG_XENO_OPT_PERVASIVE enabled List-Id: Help regarding installation and common use of Xenomai List-Unsubscribe: , List-Archive: List-Post: List-Help: List-Subscribe: , To: Gilles Chanteperdrix Cc: "xenomai@xenomai.org" I figured out the fix. There was a hard coded minor number for a misc devic= e register for the GPIO. For some reason PERVASIVE conflicted with it. Changed it to dynamic assign ID and it worked fine. Linux serial now works. On 3/21/12 3:43 AM, "Gilles Chanteperdrix" wrote: > On 03/21/2012 05:46 AM, Glen Wernersbach wrote: >> I am going to start trying to see if I can figure out what is not gettin= g >> set. >>=20 >> By the way. This board also has 4 other serial ports on a 8250.c driver.= It >> also fails under the xeno build. >=20 > But the serial console works, right? So there is at least on serial port > working. --=20 Glen Wernersbach President & CTO Jetsoft Development Co. 629 Old St Rt. 74 =AD Suite 210 Cincinnati, Oh 45244 Custom Programming Web Site: www.jetsoftdev.com Retail Products Web Site: www.scanhelp.com Phone: 513-528-6660 Fax: 513-528-3470 Cell 513-240-9929 ---- Partner for Software Technology Jacobs Automation 2365 Progress Drive Hebron, KY 41048=20 (513) 297-7550 ---- "Support Dyslexia Research"