Re: [PATCH v1 08/10] arm64: dts: qcom: qrb4210-rb2: enable wsa881x amplifier

["Alexey Klimov" <alexey.klimov@linaro.org>]

On Sat Nov 2, 2024 at 9:30 AM GMT, Konrad Dybcio wrote:
> On 1.11.2024 6:31 AM, Alexey Klimov wrote:
> > One WSA881X amplifier is connected on QRB4210 RB2 board
> > hence only mono speaker is supported. This amplifier is set
> > to work in analog mode only. Also add required powerdown
> > pins/gpios.
> > 
> > Cc: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
> > Signed-off-by: Alexey Klimov <alexey.klimov@linaro.org>
> > ---
> >  arch/arm64/boot/dts/qcom/qrb4210-rb2.dts | 45 ++++++++++++++++++++++++
> >  1 file changed, 45 insertions(+)
> > 
> > diff --git a/arch/arm64/boot/dts/qcom/qrb4210-rb2.dts b/arch/arm64/boot/dts/qcom/qrb4210-rb2.dts
> > index fc71f5930688..76b9ae1b0ebc 100644
> > --- a/arch/arm64/boot/dts/qcom/qrb4210-rb2.dts
> > +++ b/arch/arm64/boot/dts/qcom/qrb4210-rb2.dts
> > @@ -63,6 +63,16 @@ hdmi_con: endpoint {
> >  		};
> >  	};
> >  
> > +	i2c0_gpio: i2c0 {
> > +		compatible = "i2c-gpio";
> > +
> > +		sda-gpios = <&tlmm 4 GPIO_ACTIVE_HIGH>;
> > +		scl-gpios = <&tlmm 5 GPIO_ACTIVE_HIGH>;
> > +		#address-cells = <1>;
> > +		#size-cells = <0>;
> > +		status = "disabled";
>
> Does it not work with &i2c1?

Actually it does work with i2c1 (non-gpio version).
I am going to use that and will see how it behaves.

Thanks!

Best regards,
Alexey