Re: [PATCH v8 2/2] iio: adc: Add ti-ads1018 driver

["Kurt Borja" <kuurtb@gmail.com>]

On Sun Dec 14, 2025 at 9:48 AM -05, Jonathan Cameron wrote:
> On Thu, 11 Dec 2025 23:25:44 -0500
> Kurt Borja <kuurtb@gmail.com> wrote:
>
>> Add ti-ads1018 driver for Texas Instruments ADS1018 and ADS1118 SPI
>> analog-to-digital converters.
>> 
>> This chips' MOSI pin is shared with a data-ready interrupt. Defining
>> this interrupt in devicetree is optional, therefore we only create an
>> IIO trigger if one is found.
>> 
>> Handling this interrupt requires some considerations. When enabling the
>> trigger the CS line is tied low (active), thus we need to hold
>> spi_bus_lock() too, to avoid state corruption. This is done inside the
>> set_trigger_state() callback, to let users use other triggers without
>> wasting a bus lock.
>> 
>> Reviewed-by: Andy Shevchenko <andy@kernel.org>
>> Signed-off-by: Kurt Borja <kuurtb@gmail.com>
>
> Hi Kurt, 
>
> A couple of minor formatting things. All trivial so I tweaked whilst
> applying. Applied to the testing branch of iio.git. I'll rebase that
> on rc1 once available then push out as togreg for linux-next to pick
> it up.
>
> Thanks,
>
> Jonathan

Hi Jonathan,

Thank you, Andy and David for your guidance (and the little tweaks) :)

-- 
 ~ Kurt