Re: [PATCH 1/7] arm64: dts: qcom: Add PMI8996 DTSI file

[Bjorn Andersson <bjorn.andersson@linaro.org>]

On Tue 25 May 15:02 CDT 2021, Konrad Dybcio wrote:

> PMI8996 is *almost* the same hardware as PMI8994, say for some annoyances:
> 
> - Boards equipped with PMI8996 now have to include pmic-id (which wasn't the case before)
> - Different qpnp-ibb-discharge-resistor value (will be addressed after LABIBB is introduced)
> - Different inhibit-derating-ua value (will be addressed after BCL is introduced)
> - Different ramp_up_step value (will be addressed after [if?] QPNP Flash LED is introduced)
> 
> Signed-off-by: Konrad Dybcio <konrad.dybcio@somainline.org>
> ---
>  arch/arm64/boot/dts/qcom/pmi8996.dtsi | 15 +++++++++++++++
>  1 file changed, 15 insertions(+)
>  create mode 100644 arch/arm64/boot/dts/qcom/pmi8996.dtsi
> 
> diff --git a/arch/arm64/boot/dts/qcom/pmi8996.dtsi b/arch/arm64/boot/dts/qcom/pmi8996.dtsi
> new file mode 100644
> index 000000000000..31b47209e261
> --- /dev/null
> +++ b/arch/arm64/boot/dts/qcom/pmi8996.dtsi
> @@ -0,0 +1,15 @@
> +// SPDX-License-Identifier: GPL-2.0

Can we have this with BSD license (as well)?

> +/*
> + * Copyright (c) 2021, Konrad Dybcio <konrad.dybcio@somainline.org>
> + */
> +
> + /*
> +  * PMI8996 is a slight modification of PMI8994 with
> +  * some notable changes, like being the first PMIC
> +  * whose the bootloader has to check to continue booting
> +  * and a change to a LABIBB parameter.
> +  */
> +
> +/ {
> +	qcom,pmic-id = <0x20009 0x10013 0 0>;
> +};

So I'm supposed to include this and the pmi8994? I was expecting an
include of pmi8994.dtsi from here and then some override of the
necessary properties.

Regards,
Bjorn

> -- 
> 2.31.1
>