Re: [PATCH v2 1/2] devicetree: bindings: net: Add bindings doc for Sunplus SP7021.

[Andrew Lunn <andrew@lunn.ch>]

> +examples:
> +  - |
> +    #include <dt-bindings/interrupt-controller/irq.h>
> +    emac: emac@9c108000 {
> +        compatible = "sunplus,sp7021-emac";
> +        reg = <0x9c108000 0x400>, <0x9c000280 0x80>;
> +        reg-names = "emac", "moon5";
> +        interrupt-parent = <&intc>;
> +        interrupts = <66 IRQ_TYPE_LEVEL_HIGH>;
> +        clocks = <&clkc 0xa7>;
> +        resets = <&rstc 0x97>;
> +        phy-handle1 = <&eth_phy0>;
> +        phy-handle2 = <&eth_phy1>;
> +        pinctrl-0 = <&emac_demo_board_v3_pins>;
> +        pinctrl-names = "default";
> +        nvmem-cells = <&mac_addr0>, <&mac_addr1>;
> +        nvmem-cell-names = "mac_addr0", "mac_addr1";
> +
> +        mdio {
> +            #address-cells = <1>;
> +            #size-cells = <0>;
> +            eth_phy0: ethernet-phy@0 {
> +                reg = <0>;
> +                phy-mode = "rmii";

This is in the wrong place. It is a MAC property. You usually put it
next to phy-handle.

> +            };
> +            eth_phy1: ethernet-phy@1 {
> +                reg = <1>;
> +                phy-mode = "rmii";
> +            };
> +        };

I would suggest you structure this differently to make it clear it is
a two port switch:

	ethernet-ports {
		#address-cells = <1>;
                #size-cells = <0>;

                port@0 {
                    reg = <0>;
		    phy-handle = <&eth_phy0>;
		    phy-mode = "rmii";
		}

		port@1 {
                    reg = <1>;
		    phy-handle = <&eth_phy1>;
		    phy-mode = "rmii";
		}
	}

	Andrew