Re: [PATCH] clk: qcom: rpmh: Add note about sleep/wake state for BCMs

[Bjorn Andersson <bjorn.andersson@linaro.org>]

On Tue 17 May 14:09 CDT 2022, Stephen Boyd wrote:

> The sleep/wake state doesn't need to be set here because of specific
> RPMh behavior that carries over the active state when sleep/wake state
> hasn't been modified. Add a note to the code so we aren't tempted to set
> the sleep/wake states.
> 
> Cc: Alex Elder <elder@linaro.org>
> Cc: Taniya Das <quic_tdas@quicinc.com>

Reviewed-by: Bjorn Andersson <bjorn.andersson@linaro.org>

> Signed-off-by: Stephen Boyd <swboyd@chromium.org>
> ---
> 
> This superseedes a previous patch[1] I sent that tried to fix this.
> 
>  drivers/clk/qcom/clk-rpmh.c | 5 +++++
>  1 file changed, 5 insertions(+)
> 
> diff --git a/drivers/clk/qcom/clk-rpmh.c b/drivers/clk/qcom/clk-rpmh.c
> index aed907982344..c07cab6905cb 100644
> --- a/drivers/clk/qcom/clk-rpmh.c
> +++ b/drivers/clk/qcom/clk-rpmh.c
> @@ -274,6 +274,11 @@ static int clk_rpmh_bcm_send_cmd(struct clk_rpmh *c, bool enable)
>  		cmd.addr = c->res_addr;
>  		cmd.data = BCM_TCS_CMD(1, enable, 0, cmd_state);
>  
> +		/*
> +		 * Send only an active only state request. RPMh continues to
> +		 * use the active state when we're in sleep/wake state as long
> +		 * as the sleep/wake state has never been set.
> +		 */
>  		ret = clk_rpmh_send(c, RPMH_ACTIVE_ONLY_STATE, &cmd, enable);
>  		if (ret) {
>  			dev_err(c->dev, "set active state of %s failed: (%d)\n",
> 
> base-commit: 42226c989789d8da4af1de0c31070c96726d990c
> -- 
> https://chromeos.dev
> [1] https://lore.kernel.org/r/20220412194505.614002-1-swboyd@chromium.org