Re: [PATCH net-next] net: phy: micrel: Adding SQI support for lan8814 phy

[Andrew Lunn <andrew@lunn.ch>]

> +#define LAN8814_DCQ_CTRL				0xe6
> +#define LAN8814_DCQ_CTRL_READ_CAPTURE_			BIT(15)
> +#define LAN8814_DCQ_CTRL_CHANNEL_MASK			GENMASK(1, 0)
> +#define LAN8814_DCQ_SQI					0xe4
> +#define LAN8814_DCQ_SQI_MAX				7
> +#define LAN8814_DCQ_SQI_VAL_MASK			GENMASK(3, 1)
> +
>  static int lanphy_read_page_reg(struct phy_device *phydev, int page, u32 addr)
>  {
>  	int data;
> @@ -2927,6 +2934,32 @@ static int lan8814_probe(struct phy_device *phydev)
>  	return 0;
>  }
>  
> +static int lan8814_get_sqi(struct phy_device *phydev)
> +{
> +	int rc, val;
> +
> +	val = lanphy_read_page_reg(phydev, 1, LAN8814_DCQ_CTRL);
> +	if (val < 0)
> +		return val;

I just took a quick look at the datasheet. It says:

All registers references in this section are in MMD Device Address 1

So you should be using phy_read_mmd(phydev, MDIO_MMD_PMAPMD, xxx) to
read/write these registers. The datasheet i have however is missing
the register map, so i've no idea if it is still 0xe6.

    Andrew