Re: [PATCH net-next] net: mdio: Add netlink interface

["Russell King (Oracle)" <linux@armlinux.org.uk>]

On Tue, Mar 07, 2023 at 03:22:46PM +0100, Andrew Lunn wrote:
> > +		switch ((enum mdio_nl_op)insn->op) {
> > +		case MDIO_NL_OP_READ:
> > +			phy_id = __arg_ri(insn->arg0, regs);
> > +			prtad = mdio_phy_id_prtad(phy_id);
> > +			devad = mdio_phy_id_devad(phy_id);
> > +			reg = __arg_ri(insn->arg1, regs);
> > +
> > +			if (mdio_phy_id_is_c45(phy_id))
> > +				ret = __mdiobus_c45_read(xfer->mdio, prtad,
> > +							 devad, reg);
> > +			else
> > +				ret = __mdiobus_read(xfer->mdio, phy_id, reg);
> 
> The application should say if it want to do C22 or C45. As you said in
> the cover note, the ioctl interface is limiting when there is no PHY,
> so you are artificially adding the same restriction here. Also, you
> might want to do C45 on a C22 PHY, e.g. to access EEE registers. Plus
> you could consider adding C45 over C22 here.

Remembering of course that C45-over-C22 on a device that isn't a PHY
could end up causing havoc, but then if you are using this interface,
you already have the gun pointing at your foot... and if you go and
try C45-over-C22 to scan a MDIO bus, you'd definitely be pulling the
trigger too.

-- 
RMK's Patch system: https://www.armlinux.org.uk/developer/patches/
FTTP is here! 40Mbps down 10Mbps up. Decent connectivity at last!