[Issue] Bonding can't show correct speed if lower interface is bond 802.3ad

[Hangbin Liu <liuhangbin@gmail.com>]

Hi Jay,

A user reported a bonding issue that if we put an active-back bond on top of a
802.3ad bond interface. When the 802.3ad bond's speed/duplex changed
dynamically. The upper bonding interface's speed/duplex can't be changed at
the same time.

This seems not easy to fix since we update the speed/duplex only
when there is a failover(except 802.3ad mode) or slave netdev change.
But the lower bonding interface doesn't trigger netdev change when the speed
changed as ethtool get bonding speed via bond_ethtool_get_link_ksettings(),
which not affect bonding interface itself.

Here is a reproducer:

```
#!/bin/bash
s_ns="s"
c_ns="c"

ip netns del ${c_ns} &> /dev/null
ip netns del ${s_ns} &> /dev/null
sleep 1
ip netns add ${c_ns}
ip netns add ${s_ns}

ip -n ${c_ns} link add bond0 type bond mode 802.3ad miimon 100
ip -n ${s_ns} link add bond0 type bond mode 802.3ad miimon 100
ip -n ${s_ns} link add bond1 type bond mode active-backup miimon 100

for i in $(seq 0 2); do
        ip -n ${c_ns} link add eth${i} type veth peer name eth${i} netns ${s_ns}
        [ $i -eq 2 ] && break
        ip -n ${c_ns} link set eth${i} master bond0
        ip -n ${s_ns} link set eth${i} master bond0
done

ip -n ${c_ns} link set eth2 up
ip -n ${c_ns} link set bond0 up

ip -n ${s_ns} link set bond0 master bond1
ip -n ${s_ns} link set bond1 up

sleep 5

ip netns exec ${s_ns} ethtool bond0 | grep Speed
ip netns exec ${s_ns} ethtool bond1 | grep Speed
```

When run the reproducer directly, you will see:
# ./bond_topo_lacp.sh
        Speed: 20000Mb/s
        Speed: 10000Mb/s

So do you have any thoughts about how to fix it?

Thanks
Hangbin