Re: [PATCH net-next v3 4/6] net: phy: microchip_t1s: fix reset complete status handling

["Ramón Nordin Rodriguez" <ramon.nordin.rodriguez@ferroamp.se>]

> +	/* Read STS2 register and check for the Reset Complete status to do the
> +	 * init configuration. If the Reset Complete is not set, wait for 5us
> +	 * and then read STS2 register again and check for Reset Complete status.
> +	 * Still if it is failed then declare PHY reset error or else proceed
> +	 * for the PHY initial register configuration.
> +	 */
> +	err = phy_read_mmd(phydev, MDIO_MMD_VEND2, LAN867X_REG_STS2);
> +	if (err < 0)
> +		return err;
> +
> +	if (!(err & LAN867x_RESET_COMPLETE_STS)) {
> +		udelay(5);
> +		err = phy_read_mmd(phydev, MDIO_MMD_VEND2, LAN867X_REG_STS2);
> +		if (err < 0)
> +			return err;
> +		if (!(err & LAN867x_RESET_COMPLETE_STS)) {
> +			phydev_err(phydev, "PHY reset failed\n");
> +			return -ENODEV;
> +		}
> +	}

This comment explains exactly what the code does, which is also obvious
from reading the code. A meaningful comment would be explaining why the
state can change 5us later.