From: Dave Chinner <david@fromorbit.com>
To: "Darrick J. Wong" <djwong@kernel.org>
Cc: linux-xfs@vger.kernel.org
Subject: Re: [PATCH] xfs: AGF length has never been bounds checked
Date: Fri, 16 Jun 2023 16:34:58 +1000 [thread overview]
Message-ID: <ZIwCknB7YDRqvXe1@dread.disaster.area> (raw)
In-Reply-To: <20230616041901.GR11441@frogsfrogsfrogs>
On Thu, Jun 15, 2023 at 09:19:01PM -0700, Darrick J. Wong wrote:
> On Fri, Jun 16, 2023 at 11:59:06AM +1000, Dave Chinner wrote:
> > From: Dave Chinner <dchinner@redhat.com>
> >
> > The AGF verifier does not check that the AGF length field is within
> > known good bounds. This has never been checked by runtime kernel
> > code (i.e. the lack of verification goes back to 1993) yet we assume
>
> Woo hoo!
>
> > in many places that it is correct and verify other metdata against
> > it.
> >
> > Add length verification to the AGF verifier. The length of the AGF
> > must be equal to the size of the AG specified in the superblock,
> > unless it is the last AG in the filesystem. In that case, it must be
> > less than or equal to sb->sb_agblocks and greater than
> > XFS_MIN_AG_BLOCKS, which is the smallest AG a growfs operation will
> > allow to exist.
> >
> > This requires a bit of rework of the verifier function. We want to
> > verify metadata before we use it to verify other metadata. Hence
> > we need to verify the AGF sequence numbers before using them to
> > verify the length of the AGF. Then we can verify the AGF length
> > before we verify AGFL fields. Then we can verifier other fields that
> > are bounds limited by the AGF length.
> >
> > And, finally, by calculating agf_length only once into a local
> > variable, we can collapse repeated "if (xfs_has_foo() &&"
> > conditionaly checks into single checks. This makes the code much
> > easier to follow as all the checks for a given feature are obviously
> > in the same place.
> >
> > Signed-off-by: Dave Chinner <dchinner@redhat.com>
> > ---
> > fs/xfs/libxfs/xfs_alloc.c | 81 ++++++++++++++++++++++-----------------
> > 1 file changed, 46 insertions(+), 35 deletions(-)
> >
> > diff --git a/fs/xfs/libxfs/xfs_alloc.c b/fs/xfs/libxfs/xfs_alloc.c
> > index 7c675aae0a0f..78556cad57e5 100644
> > --- a/fs/xfs/libxfs/xfs_alloc.c
> > +++ b/fs/xfs/libxfs/xfs_alloc.c
> > @@ -2970,6 +2970,7 @@ xfs_agf_verify(
> > {
> > struct xfs_mount *mp = bp->b_mount;
> > struct xfs_agf *agf = bp->b_addr;
> > + uint32_t agf_length = be32_to_cpu(agf->agf_length);
> >
> > if (xfs_has_crc(mp)) {
> > if (!uuid_equal(&agf->agf_uuid, &mp->m_sb.sb_meta_uuid))
> > @@ -2981,18 +2982,38 @@ xfs_agf_verify(
> > if (!xfs_verify_magic(bp, agf->agf_magicnum))
> > return __this_address;
> >
> > - if (!(XFS_AGF_GOOD_VERSION(be32_to_cpu(agf->agf_versionnum)) &&
> > - be32_to_cpu(agf->agf_freeblks) <= be32_to_cpu(agf->agf_length) &&
> > - be32_to_cpu(agf->agf_flfirst) < xfs_agfl_size(mp) &&
> > - be32_to_cpu(agf->agf_fllast) < xfs_agfl_size(mp) &&
> > - be32_to_cpu(agf->agf_flcount) <= xfs_agfl_size(mp)))
> > + if (!(XFS_AGF_GOOD_VERSION(be32_to_cpu(agf->agf_versionnum))))
> > return __this_address;
> >
> > - if (be32_to_cpu(agf->agf_length) > mp->m_sb.sb_dblocks)
> > + /*
> > + * during growfs operations, the perag is not fully initialised,
> > + * so we can't use it for any useful checking. growfs ensures we can't
> > + * use it by using uncached buffers that don't have the perag attached
> > + * so we can detect and avoid this problem.
>
> Would you mind adding an extra sentence here:
>
> "Both agf_seqno and agf_length need to be validated before anything else
> fsblock related in the AGF."
Yup.
> > + */
> > + if (bp->b_pag && be32_to_cpu(agf->agf_seqno) != bp->b_pag->pag_agno)
> > + return __this_address;
> > +
> > + /*
> > + * Only the last AGF in the filesytsem is allowed to be shorter
> > + * than the AG size recorded in the superblock.
> > + */
> > + if (agf_length != mp->m_sb.sb_agblocks) {
> > + if (be32_to_cpu(agf->agf_seqno) != mp->m_sb.sb_agcount - 1)
> > + return __this_address;
> > + if (agf_length < XFS_MIN_AG_BLOCKS)
>
> The superblock verifier checks that sb_agblocks >= XFS_MIN_AG_BYTES,
> which means that it can't be less than 16MB. That's the lower bound on
> the general AG size, not the lower bound of a runt AG at the end of the
> fs.
*nod*
> OTOH, the lower bound of a runt AG is XFS_MIN_AG_BLOCKS, or 64FSB. I
> would sorta like this to be outside this sub-block since that's
> independent of whatever sb_agblocks is.
>
> That said, there is no filesystem where setting sb_agblocks to 16MB
> would result in an sb_agblocks with a value less than 256, so I suppose
> this is a moot worry of mine.
>
> Does that make sense?
*nod*.
The sb verifier is checking valid sb_agblocks bounds, and this is
just checking the invariant that all AGs must be the same size as
sb_agblocks, except for the runt AG. The runt AG has bounds of
XFS_MIN_AG_BLOCKS <= agf_length <= sb_agblocks, so we check those
here...
> > + return __this_address;
> > + if (agf_length > mp->m_sb.sb_agblocks)
> > + return __this_address;
> > + }
> > +
> > + if (be32_to_cpu(agf->agf_flfirst) >= xfs_agfl_size(mp) ||
> > + be32_to_cpu(agf->agf_fllast) >= xfs_agfl_size(mp) ||
> > + be32_to_cpu(agf->agf_flcount) > xfs_agfl_size(mp))
> > return __this_address;
>
> I wish each check would get its own return __this_address. Today I was
> debugging some dumb bug but addr2line dropped me off in the middle of
> this mound of code. :(
I've got to revise it for the comment above, so I can do that
easily enough here too.
Cheers,
Dave.
--
Dave Chinner
david@fromorbit.com
next prev parent reply other threads:[~2023-06-16 6:35 UTC|newest]
Thread overview: 4+ messages / expand[flat|nested] mbox.gz Atom feed top
2023-06-16 1:59 [PATCH] xfs: AGF length has never been bounds checked Dave Chinner
2023-06-16 4:19 ` Darrick J. Wong
2023-06-16 6:34 ` Dave Chinner [this message]
2023-06-16 7:41 ` Christoph Hellwig
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=ZIwCknB7YDRqvXe1@dread.disaster.area \
--to=david@fromorbit.com \
--cc=djwong@kernel.org \
--cc=linux-xfs@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.