Re: [PATCH] media: ipu-bridge: fix error code in ipu_bridge_init()

[Andy Shevchenko <andriy.shevchenko@linux.intel.com>]

On Fri, May 10, 2024 at 06:27:30PM +0300, Dan Carpenter wrote:
> On Fri, May 10, 2024 at 06:18:22PM +0300, Andy Shevchenko wrote:
> > On Fri, May 10, 2024 at 06:10:37PM +0300, Dan Carpenter wrote:
> > > Return -EINVAL if "bridge->n_sensors == 0".  Don't return success.

...

> > >  	ret = ipu_bridge_connect_sensors(bridge);
> > > -	if (ret || bridge->n_sensors == 0)
> > > +	if (ret || bridge->n_sensors == 0) {
> > > +		ret = ret ?: -EINVAL;
> > >  		goto err_unregister_ipu;
> > > +	}
> > 
> > I would split:
> > 
> > 	ret = ipu_bridge_connect_sensors(bridge);
> > 	if (ret)
> > 		goto err_unregister_ipu;
> > 
> > 	if (bridge->n_sensors == 0) {
> > 		ret = -EINVAL;
> > 		goto err_unregister_ipu;
> > 	}
> 
> It's always hard to know which way to go on these...  I wrote it that
> way in my first draft.  It's my prefered way as well but not everyone
> agrees.  I'll resend.

Is the generated assembly the same?

-- 
With Best Regards,
Andy Shevchenko