Re: [PATCH] Input: ilitek_ts_i2c: Use gpiod_set_value_cansleep()

[Dmitry Torokhov <dmitry.torokhov@gmail.com>]

Hi Matthijs,

On Wed, May 15, 2024 at 04:49:44PM +0200, Matthijs Kooijman wrote:
> Use gpiod_set_value_cansleep in the ilitek_reset function (called only
> from ilitek_ts_i2c_probe and ilitek_resume).
> 
> Without this change, the driver may print a warning if the reset pin is
> connected to a GPIO chip which can sleep (e.g. a GPIO expander):
> 
> WARNING: CPU: 1 PID: 578 at gpiod_set_value+0x5c/0xd0
> 
> This commit is modeled after commit 7c977019c53ed (leds: lp55xx: Use
> gpiod_set_value_cansleep(), 2023-09-18)
> 
> Signed-off-by: Matthijs Kooijman <matthijs@stdin.nl>
> ---
>  drivers/input/touchscreen/ilitek_ts_i2c.c | 4 ++--
>  1 file changed, 2 insertions(+), 2 deletions(-)
> 
> diff --git a/drivers/input/touchscreen/ilitek_ts_i2c.c b/drivers/input/touchscreen/ilitek_ts_i2c.c
> index fc4e39b6651a4..236c332de6cdc 100644
> --- a/drivers/input/touchscreen/ilitek_ts_i2c.c
> +++ b/drivers/input/touchscreen/ilitek_ts_i2c.c
> @@ -391,9 +391,9 @@ static const struct ilitek_protocol_map ptl_func_map[] = {
>  static void ilitek_reset(struct ilitek_ts_data *ts, int delay)
>  {
>  	if (ts->reset_gpio) {
> -		gpiod_set_value(ts->reset_gpio, 1);
> +		gpiod_set_value_cansleep(ts->reset_gpio, 1);
>  		mdelay(10);
> -		gpiod_set_value(ts->reset_gpio, 0);
> +		gpiod_set_value_cansleep(ts->reset_gpio, 0);
>  		mdelay(delay);

While we are changing GPIO to the sleeping variant we should also change
these mdelays to usleep_range() and msleep() respectively.

Thanks.

-- 
Dmitry