Re: [PATCH v5 2/3] iio: accel: sca3000: replace usages of internal read data helpers by spi helpers

[Andy Shevchenko <andriy.shevchenko@intel.com>]

On Wed, Jun 11, 2025 at 04:39:20PM -0300, Andrew Ijano wrote:
> Remove usages of sca3000_read_data() and sca3000_read_data_short()
> functions, replacing it by spi_w8r8() and spi_w8r16be() helpers. Just
> one case that reads large buffers is left using an internal helper.
> 
> This is an old driver that was not making full use of the newer
> infrastructure.

...

> +	ret |= (mode & SCA3000_REG_MODE_MODE_MASK);

Unneeded parentheses.

...

> +			ret = spi_w8r16be(st->us,
> +						SCA3000_READ_REG(SCA3000_REG_TEMP_MSB_ADDR));

Make it simply one line. The above formatting is ugly.

...

>  	struct iio_dev *indio_dev = dev_to_iio_dev(dev);
>  	struct sca3000_state *st = iio_priv(indio_dev);
> -	int len = 0, ret, val;
> +	int len = 0, ret;

Ideally it's better to split them and len should never be signed.
Moreover, the function  should be switched to sysfs_emit_at() if this is part
of ABI.

>  	mutex_lock(&st->lock);
> -	ret = sca3000_read_data_short(st, SCA3000_REG_MODE_ADDR, 1);
> -	val = st->rx[0];
> +	ret = spi_w8r8(st->us, SCA3000_READ_REG(SCA3000_REG_MODE_ADDR));
>  	mutex_unlock(&st->lock);
>  	if (ret)
>  		return ret;

...

>  		}, {
>  			.len = len,
> -			.rx_buf = rx,
> +			.rx_buf = st->rx,
>  		}
>  	};

> -

Stray change. Doesn't checkpatch complain on this?

> -			(st->rx[0] | SCA3000_REG_MODE_RING_BUF_ENABLE));
> +			(ret | SCA3000_REG_MODE_RING_BUF_ENABLE));

> -			(st->rx[0] & ~SCA3000_REG_MODE_RING_BUF_ENABLE));
> +			(ret & ~SCA3000_REG_MODE_RING_BUF_ENABLE));

In the original code and still now too many parentheses.

-- 
With Best Regards,
Andy Shevchenko