Re: [RFC PATCH 0/3] iio: adc: Add support for TI ADS1120 ADC

[Andy Shevchenko <andriy.shevchenko@intel.com>]

On Sat, Nov 01, 2025 at 05:07:38PM +0530, Ajith Anandhan wrote:
> On 10/31/25 2:07 PM, Andy Shevchenko wrote:
> > On Thu, Oct 30, 2025 at 10:04:08PM +0530, Ajith Anandhan wrote:
> > > This RFC patch series adds support for the Texas Instruments ADS1120,
> > > a precision 16-bit delta-sigma ADC with SPI interface.
> > > 
> > > The driver provides:
> > > - 4 single-ended voltage input channels
> > > - Programmable gain amplifier (1 to 128)
> > > - Configurable data rates (20 to 1000 SPS)
> > > - Single-shot conversion mode
> > > 
> > > I'm looking for feedback on:
> > > 1. The implementation approach for single-shot conversions
> > > 2. Any other suggestions for improvement
> > > 
> > > Datasheet: https://www.ti.com/lit/gpn/ads1120
> > The cover letter missed to answer the Q: Why a new driver? Have you checked the
> > existing drivers? Do we have a similar enough one that may be extended to
> > support this chip?
> > 
> Thank you for the feedback.
> 
> I evaluated the following existing driver before creating a new one:
> 
> ads124s08.c - TI ADS124S08
> 
> - This is the closest match (both are delta-sigma, SPI-based)
> 
> - However, significant differences exist:
> 
>     * Different register layout (ADS124S08 has more registers)
> 
>     * Different command set ADS124S08 has built-in MUX for differential
> inputs
> 
>     * Different register addressing and bit fields and conversion timing and
> data retrieval.
> 
> would require extensive conditional code paths that might reduce
> maintainability for both devices. A separate, focused driver seemed cleaner.

Good, please add this summary to the cover letter of next version.

-- 
With Best Regards,
Andy Shevchenko