Re: [PATCH net-next v2 11/11] net: stmmac: ingenic: use ->set_phy_intf_sel()

[Simon Horman <horms@kernel.org>]

On Thu, Nov 06, 2025 at 08:58:10AM +0000, Russell King (Oracle) wrote:
> Rather than placing the phy_intf_sel() setup in the ->init() method,
> move it to the new ->set_phy_intf_sel() method.
> 
> Signed-off-by: Russell King (Oracle) <rmk+kernel@armlinux.org.uk>
> ---
>  .../ethernet/stmicro/stmmac/dwmac-ingenic.c   | 33 +++++++------------
>  1 file changed, 11 insertions(+), 22 deletions(-)
> 
> diff --git a/drivers/net/ethernet/stmicro/stmmac/dwmac-ingenic.c b/drivers/net/ethernet/stmicro/stmmac/dwmac-ingenic.c
> index 41a2071262bc..957bc78d5a1e 100644
> --- a/drivers/net/ethernet/stmicro/stmmac/dwmac-ingenic.c
> +++ b/drivers/net/ethernet/stmicro/stmmac/dwmac-ingenic.c
> @@ -134,32 +134,21 @@ static int x2000_mac_set_mode(struct ingenic_mac *mac, u8 phy_intf_sel)
>  	return regmap_update_bits(mac->regmap, 0, mac->soc_info->mask, val);
>  }
>  
> -static int ingenic_mac_init(struct platform_device *pdev, void *bsp_priv)
> +static int ingenic_set_phy_intf_sel(void *bsp_priv, u8 phy_intf_sel)
>  {
>  	struct ingenic_mac *mac = bsp_priv;
> -	phy_interface_t interface;
> -	int phy_intf_sel, ret;
> -
> -	if (mac->soc_info->set_mode) {
> -		interface = mac->plat_dat->phy_interface;
> -
> -		phy_intf_sel = stmmac_get_phy_intf_sel(interface);
> -		if (phy_intf_sel < 0 || phy_intf_sel >= BITS_PER_BYTE ||
> -		    ~mac->soc_info->valid_phy_intf_sel & BIT(phy_intf_sel)) {
> -			dev_err(mac->dev, "unsupported interface %s\n",
> -				phy_modes(interface));
> -			return phy_intf_sel < 0 ? phy_intf_sel : -EINVAL;
> -		}
>  
> -		dev_dbg(mac->dev, "MAC PHY control register: interface %s\n",
> -			phy_modes(interface));
> +	if (!mac->soc_info->set_mode)
> +		return 0;
>  
> -		ret = mac->soc_info->set_mode(mac, phy_intf_sel);
> -		if (ret)
> -			return ret;
> -	}
> +	if (phy_intf_sel >= BITS_PER_BYTE ||
> +	    ~mac->soc_info->valid_phy_intf_sel & BIT(phy_intf_sel))
> +		return phy_intf_sel < 0 ? phy_intf_sel : -EINVAL;

nit from Smatch: phy_intf_sel is unsigned and thus cannot be negative

> +
> +	dev_dbg(mac->dev, "MAC PHY control register: interface %s\n",
> +		phy_modes(mac->plat_dat->phy_interface));
>  
> -	return 0;
> +	return mac->soc_info->set_mode(mac, phy_intf_sel);
>  }

...