Hardware clock on the Pioneer

[Michael Orlitzky <michael@orlitzky.com>]

Hello, I finally have the upstream kernel running on my Pioneer Box,
and I notice that the hardware clock is not enabled. I've patched this
in my own kernel (sg2042-milkv-pioneer.dts) by enabling i2c0, defining
the RTC,

  &i2c0 {
    pinctrl-0 = <&i2c0_cfg>;
    pinctrl-names = "default";
    status = "okay";

      rtc: rtc@68 {
        compatible = "dallas,ds1307";
        reg = <0x68>;
    };
  };

and copying the pinctrl bits from i2c1:

  i2c0_cfg: i2c0-cfg {
    i2c0-pins {
      pinmux = <PINMUX(PIN_IIC0_SDA, 0)>,
               <PINMUX(PIN_IIC0_SCL, 0)>;
      bias-pull-up;
      drive-strength-microamp = <26800>;
      input-schmitt-enable;
    };
  };

It seems to work:

  $ sudo hwclock --show
  2025-12-30 17:54:05.093606-05:00

Is there a reason not to do this? The sophgo upstream status page says
that the RTC is "Low priority, may not be needed." But if the above is
OK, I will submit a patch for it.