> On Wed, Jan 14, 2026 at 11:35:10PM +0100, Lorenzo Bianconi wrote:
> > > > In the current codebase the NPU driver does not need to access the WiFi PCIe
> > > > slot (or any other external device) since the offloading (wired and wireless)
> > > > is fully managed by the NPU chip (hw + firmware binaries).
> > > 
> > > Are you saying the NPU itself enumerates the PCI busses and finds the
> > > WiFi device?  If it can do that, why not ask it which PCI device it is
> > > using?
> > 
> > nope, we do not need any PCI enumeration in the NPU driver at the moment
> > (please see below).
> > 
> > > 
> > > Or this the PCI slot to use somehow embedded within the firmware?
> > 
> > in the current implementation the NPU driver does not need any reference to
> > WiFi or Ethernet devices. The NPU exports offloading APIs to consumer devices
> > (e.g. WiFi or Ethernet devices). In particular,
> > 1- during NPU module probe, the NPU driver configures NPU hw registers and
> >    loads the NPU firmware binaries.
> > 2- NPU consumers (ethernet and/or wifi devices) get a reference to the NPU
> >    device via device-tree in order to consume NPU APIs for offloading.
> > 3- netfilter flowtable offloads traffic to the selected ethernet and/or WiFi
> >    device that runs the NPU APIs accessible via the NPU reference obtained via
> >    dts.
> > 
> > The issue here is the NPU firmware binaries for EN7581, loaded by the NPU
> > driver during NPU probe and used for offloading, depend on the WiFi chipset
> > (e.g. MT7996 or MT7992) available on the EN7581 board (we have two different
> > NPU binaries for MT7996 offloading and for MT7992 offloading).
> 
> Maybe i'm getting the NPU wrong, but i assumed it was directly talking
> to the Ethernet and WiFi device on the PCIe bus, bypassing the host?

correct

> If so, it most somehow know what PCIe slots these devices use?

I have low visibility on the NPU hw internals but I do not think there are
any registers in NPU mmio memory where we can read this info, but I will
confirm it (please remember the fw binaries are not load yet).

Regards,
Lorenzo

> 
>    Andrew