All of lore.kernel.org
 help / color / mirror / Atom feed
From: Antoine Tenart <atenart@kernel.org>
To: Michael Bommarito <michael.bommarito@gmail.com>
Cc: "David S . Miller" <davem@davemloft.net>,
	 Eric Dumazet <edumazet@google.com>,
	Jakub Kicinski <kuba@kernel.org>,
	 Paolo Abeni <pabeni@redhat.com>,
	Antoine Tenart <atenart@kernel.org>,
	 Simon Horman <horms@kernel.org>,
	Tom Herbert <tom@herbertland.com>,
	netdev@vger.kernel.org,  linux-kernel@vger.kernel.org,
	stable@vger.kernel.org
Subject: Re: [PATCH net v2] ila: reload IPv6 header after pskb_may_pull in checksum adjust
Date: Wed, 22 Jul 2026 09:26:33 +0200	[thread overview]
Message-ID: <amBwgPWFb8UIxssF@kwain> (raw)
In-Reply-To: <20260714114903.3763420-1-michael.bommarito@gmail.com>

On Tue, Jul 14, 2026 at 07:49:03AM -0400, Michael Bommarito wrote:
> ila_csum_adjust_transport() caches ip6h = ipv6_hdr(skb) before calling
> pskb_may_pull(). On a non-linear skb whose transport header sits in a page
> fragment, pskb_may_pull() can call __pskb_pull_tail() / pskb_expand_head()
> and free the old skb head, leaving ip6h dangling; the following
> get_csum_diff(ip6h, p) then reads freed memory. ila_update_ipv6_locator()
> uses ip6h (and the iaddr derived from it) again after the csum-adjust
> call and additionally writes the new locator through that pointer.
> 
> Impact: a remote IPv6 packet routed through a configured ILA
> csum-adjust-transport route or receive-side mapping triggers a
> slab-use-after-free in ila_update_ipv6_locator() (KASAN). The route or
> mapping requires CAP_NET_ADMIN to configure, but trigger packets are
> unauthenticated once it exists.
> 
> Reload ip6h after each pskb_may_pull() in ila_csum_adjust_transport()
> before the csum-diff read. In ila_update_ipv6_locator() only the
> ILA_CSUM_ADJUST_TRANSPORT case pulls the skb, so reload ip6h and iaddr in
> that case alone before the destination-address write; the neutral-map
> modes never pull and keep their cached pointers.
> 
> Fixes: 33f11d16142b ("ila: Create net/ipv6/ila directory")
> Cc: stable@vger.kernel.org
> Assisted-by: Claude:claude-opus-4-8
> Signed-off-by: Michael Bommarito <michael.bommarito@gmail.com>

Reviewed-by: Antoine Tenart <atenart@kernel.org>

Thanks!
Antoine

> ---
> v2: In ila_update_ipv6_locator() reload ip6h/iaddr only in the
>     ILA_CSUM_ADJUST_TRANSPORT case instead of unconditionally, per
>     Antoine Tenart's review; the neutral-map modes never pull the skb,
>     so their cached pointers remain valid.
> v1: https://lore.kernel.org/netdev/20260711150648.2915106-1-michael.bommarito@gmail.com/
> 
> Evidence: a KUnit case on UML+KASAN drives ila_update_ipv6_locator()
> with a non-linear skb whose transport header sits in a fragment, so the
> pskb_may_pull() in ila_csum_adjust_transport() reallocates the head.
> Stock: BUG: KASAN: slab-use-after-free in ila_update_ipv6_locator, Read of
> size 4 (the stale ip6h/iaddr). Patched: both the valid-linear control and
> the fragmented case pass, KASAN-clean. Built clean, no new warnings.
> 
> 
>  net/ipv6/ila/ila_common.c | 12 ++++++++++++
>  1 file changed, 12 insertions(+)
> 
> diff --git a/net/ipv6/ila/ila_common.c b/net/ipv6/ila/ila_common.c
> index e71571455c8a0..b78179bfc4c72 100644
> --- a/net/ipv6/ila/ila_common.c
> +++ b/net/ipv6/ila/ila_common.c
> @@ -85,6 +85,7 @@ static void ila_csum_adjust_transport(struct sk_buff *skb,
>  			struct tcphdr *th = (struct tcphdr *)
>  					(skb_network_header(skb) + nhoff);
>  
> +			ip6h = ipv6_hdr(skb);
>  			diff = get_csum_diff(ip6h, p);
>  			inet_proto_csum_replace_by_diff(&th->check, skb,
>  							diff, true, true);
> @@ -96,6 +97,7 @@ static void ila_csum_adjust_transport(struct sk_buff *skb,
>  					(skb_network_header(skb) + nhoff);
>  
>  			if (uh->check || skb->ip_summed == CHECKSUM_PARTIAL) {
> +				ip6h = ipv6_hdr(skb);
>  				diff = get_csum_diff(ip6h, p);
>  				inet_proto_csum_replace_by_diff(&uh->check, skb,
>  								diff, true, true);
> @@ -110,6 +112,7 @@ static void ila_csum_adjust_transport(struct sk_buff *skb,
>  			struct icmp6hdr *ih = (struct icmp6hdr *)
>  					(skb_network_header(skb) + nhoff);
>  
> +			ip6h = ipv6_hdr(skb);
>  			diff = get_csum_diff(ip6h, p);
>  			inet_proto_csum_replace_by_diff(&ih->icmp6_cksum, skb,
>  							diff, true, true);
> @@ -127,6 +130,15 @@ void ila_update_ipv6_locator(struct sk_buff *skb, struct ila_params *p,
>  	switch (p->csum_mode) {
>  	case ILA_CSUM_ADJUST_TRANSPORT:
>  		ila_csum_adjust_transport(skb, p);
> +		/*
> +		 * ila_csum_adjust_transport() calls pskb_may_pull(), which can
> +		 * reallocate the skb head and leave ip6h (and the iaddr derived
> +		 * from it) dangling; reload both before the write below.  The
> +		 * other csum modes do not pull, so their cached pointers stay
> +		 * valid.
> +		 */
> +		ip6h = ipv6_hdr(skb);
> +		iaddr = ila_a2i(&ip6h->daddr);
>  		break;
>  	case ILA_CSUM_NEUTRAL_MAP:
>  		if (sir2ila) {
> -- 
> 2.53.0
> 

  parent reply	other threads:[~2026-07-22  7:26 UTC|newest]

Thread overview: 4+ messages / expand[flat|nested]  mbox.gz  Atom feed  top
2026-07-14 11:49 [PATCH net v2] ila: reload IPv6 header after pskb_may_pull in checksum adjust Michael Bommarito
2026-07-21 16:03 ` Simon Horman
2026-07-22  7:26 ` Antoine Tenart [this message]
2026-07-22 21:10 ` patchwork-bot+netdevbpf

Reply instructions:

You may reply publicly to this message via plain-text email
using any one of the following methods:

* Save the following mbox file, import it into your mail client,
  and reply-to-all from there: mbox

  Avoid top-posting and favor interleaved quoting:
  https://en.wikipedia.org/wiki/Posting_style#Interleaved_style

* Reply using the --to, --cc, and --in-reply-to
  switches of git-send-email(1):

  git send-email \
    --in-reply-to=amBwgPWFb8UIxssF@kwain \
    --to=atenart@kernel.org \
    --cc=davem@davemloft.net \
    --cc=edumazet@google.com \
    --cc=horms@kernel.org \
    --cc=kuba@kernel.org \
    --cc=linux-kernel@vger.kernel.org \
    --cc=michael.bommarito@gmail.com \
    --cc=netdev@vger.kernel.org \
    --cc=pabeni@redhat.com \
    --cc=stable@vger.kernel.org \
    --cc=tom@herbertland.com \
    /path/to/YOUR_REPLY

  https://kernel.org/pub/software/scm/git/docs/git-send-email.html

* If your mail client supports setting the In-Reply-To header
  via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.