Re: [PATCH v2 08/11] media: atomisp: support the Yoga Book OV2740 link

[Andy Shevchenko <andriy.shevchenko@intel.com>]

On Thu, Aug 27, 2026 at 08:17:53PM +0200, Maurizio Casciano wrote:
> The YB1-X91L firmware does not describe the complete camera link. Its
> front OV2740 uses two CSI-2 lanes at a 288 MHz link frequency and sends
> a 1932x1092 BGGR transport frame with 12 pixels of horizontal and
> vertical padding around the 1920x1080 image.
> 
> Allow the AtomISP bridge to provide per-sensor link frequencies and
> padding, add the matching OV2740 mode, and derive ISP2401 D-PHY timing
> from the sensor link-frequency control.
> 
> The register values are hardware configuration facts checked against
> the Lenovo YB1-X91L configuration and physical captures; no proprietary
> driver code or tuning binary is included.
> 
> Tested on a Lenovo Yoga Book YB1-X91L with continuous front-camera raw
> capture.

...

> +bool atomisp_csi2_get_sensor_padding(struct device *dev,
> +				     struct v4l2_area *padding)
> +{
> +	struct acpi_device *adev;
> +
> +	padding->width = pad_w;
> +	padding->height = pad_h;
> +
> +	adev = ACPI_COMPANION(dev);
> +	if (!adev)
> +		return false;

> +	padding->width = atomisp_csi2_get_padding_value(adev,
> +							"CsiPaddingWidth", pad_w);

	padding->width =
		atomisp_csi2_get_padding_value(adev, "CsiPaddingWidth", pad_w);


> +	padding->height = atomisp_csi2_get_padding_value(adev,
> +							 "CsiPaddingHeight", pad_h);

In the similar way.

> +	return padding->width != pad_w || padding->height != pad_h;
> +}

...

> -	ATOMISP_SENSOR_CONFIG("INT33BE", 2, false),	/* OV5693 */
> -	ATOMISP_SENSOR_CONFIG("INT3477", 4, true),	/* OV8858 */
> -	ATOMISP_SENSOR_CONFIG("OVTI2740", 2, false),	/* OV2740 */
> +	ATOMISP_SENSOR_CONFIG("INT33BE", 2, false, 0),	/* OV5693 */
> +	ATOMISP_SENSOR_CONFIG("INT3477", 4, true, 0),	/* OV8858 */
> +	/* OV2740 */
> +	ATOMISP_SENSOR_CONFIG("OVTI2740", 2, false, 288 * HZ_PER_MHZ),

It's better to keep style

	/* OV5693 */
	ATOMISP_SENSOR_CONFIG("INT33BE", 2, false, 0),
	/* OV8858 */
	ATOMISP_SENSOR_CONFIG("INT3477", 4, true, 0),
	/* OV2740 */
	ATOMISP_SENSOR_CONFIG("OVTI2740", 2, false, 288 * HZ_PER_MHZ),

Check if that can be done in the previous patch(es) already.

-- 
With Best Regards,
Andy Shevchenko