From: Andy Shevchenko <andriy.shevchenko@intel.com>
To: Maurizio Casciano <mauriziocasciano7@gmail.com>
Cc: mchehab@kernel.org, linux-media@vger.kernel.org,
sakari.ailus@linux.intel.com, bingbu.cao@amd.com,
jacopo.mondi@ideasonboard.com, nicholas@rothemail.net,
andy@kernel.org, hansg@kernel.org, gregkh@linuxfoundation.org,
linux-staging@lists.linux.dev, linux-kernel@vger.kernel.org
Subject: Re: [PATCH v7 00/16] media: Add Yoga Book camera support
Date: Thu, 3 Sep 2026 07:44:30 +0300 [thread overview]
Message-ID: <apj7LiYzFEIByPvV@ashevche-desk.local> (raw)
In-Reply-To: <cover.1788360629.git.mauriziocasciano7@gmail.com>
On Wed, Sep 02, 2026 at 04:53:29PM +0200, Maurizio Casciano wrote:
>
> This series adds the sensor, bridge, AtomISP and lens-actuator support
> needed by the front and rear cameras of the Lenovo Yoga Book YB1-X91.
>
> It covers the OV8858 19.2 MHz clock and Cherry Trail gain programming,
> OV2740 288 MHz link frequency and manual white balance, firmware IDs and
> IPU bridge data, AtomISP raw capture and CSI-2 timing, and the WV517S lens
> actuator.
> Changes in v7:
> - In patch 2, keep digital gain independent of the external clock and
> expose the manual red and blue gains as separate controls, as requested
> by Sakari Ailus. Keep green at unity and accumulate register-write
> errors across the three manual white-balance channels.
> - Move the 24 MHz PLL and global timing registers out of the common mode
> tables into revision- and lane-specific arrays. Select both 19.2 MHz and
> 24 MHz clock programming explicitly when starting a stream.
> - Clarify the patch 2 assistance disclosure as
> `Assisted-by: LLM [Codex] [Sparse]`.
> - No changes to patches 1 and 3 through 16.
Wait at least a few days before sending a new version.
There will be a v8 as far as I can tell, but send it next week after all comments
were addressed (or settled down).
--
With Best Regards,
Andy Shevchenko
next prev parent reply other threads:[~2026-09-03 4:44 UTC|newest]
Thread overview: 24+ messages / expand[flat|nested] mbox.gz Atom feed top
2026-09-02 14:53 [PATCH v7 00/16] media: Add Yoga Book camera support Maurizio Casciano
2026-09-02 14:53 ` [PATCH v7 01/16] media: ov8858: Extract digital gain programming Maurizio Casciano
2026-09-02 14:53 ` [PATCH v7 02/16] media: ov8858: support 19.2 MHz clock and CHT gain setup Maurizio Casciano
2026-09-03 4:42 ` Andy Shevchenko
2026-09-02 14:53 ` [PATCH v7 03/16] media: ov2740: Use C99 initializers for ACPI IDs Maurizio Casciano
2026-09-02 14:53 ` [PATCH v7 04/16] media: ov2740: Add OVTI2740 ACPI ID Maurizio Casciano
2026-09-03 5:35 ` Andy Shevchenko
2026-09-02 14:53 ` [PATCH v7 05/16] media: ov8858: Add INT3477 " Maurizio Casciano
2026-09-02 14:53 ` [PATCH v7 06/16] media: intel: ipu-bridge: Add Yoga Book camera sensors Maurizio Casciano
2026-09-02 14:53 ` [PATCH v7 07/16] media: atomisp: Add Yoga Book camera configuration Maurizio Casciano
2026-09-02 14:53 ` [PATCH v7 08/16] media: ov2740: support 288 MHz link frequency Maurizio Casciano
2026-09-02 14:53 ` [PATCH v7 09/16] media: intel: ipu-bridge: allow sensor-specific link frequencies Maurizio Casciano
2026-09-03 7:01 ` Andy Shevchenko
2026-09-02 14:53 ` [PATCH v7 10/16] media: atomisp: derive CSI-2 timing from sensor link frequency Maurizio Casciano
2026-09-02 14:53 ` [PATCH v7 11/16] media: atomisp: provide Yoga Book OV2740 " Maurizio Casciano
2026-09-02 14:53 ` [PATCH v7 12/16] media: ov2740: release group hold after gain write errors Maurizio Casciano
2026-09-02 14:53 ` [PATCH v7 13/16] media: ov2740: add manual white balance controls Maurizio Casciano
2026-09-02 14:53 ` [PATCH v7 14/16] media: atomisp: Use struct v4l2_area for padding Maurizio Casciano
2026-09-03 7:04 ` Andy Shevchenko
2026-09-02 14:53 ` [PATCH v7 15/16] media: atomisp: allow raw Bayer capture Maurizio Casciano
2026-09-03 7:12 ` Andy Shevchenko
2026-09-02 14:53 ` [PATCH v7 16/16] media: i2c: Add WV517S lens actuator driver Maurizio Casciano
2026-09-03 4:44 ` Andy Shevchenko [this message]
2026-09-03 5:37 ` [PATCH v7 00/16] media: Add Yoga Book camera support Andy Shevchenko
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=apj7LiYzFEIByPvV@ashevche-desk.local \
--to=andriy.shevchenko@intel.com \
--cc=andy@kernel.org \
--cc=bingbu.cao@amd.com \
--cc=gregkh@linuxfoundation.org \
--cc=hansg@kernel.org \
--cc=jacopo.mondi@ideasonboard.com \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-media@vger.kernel.org \
--cc=linux-staging@lists.linux.dev \
--cc=mauriziocasciano7@gmail.com \
--cc=mchehab@kernel.org \
--cc=nicholas@rothemail.net \
--cc=sakari.ailus@linux.intel.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.