Re: [PATCH v2] ASoC: wm8962: Stop IRQ from requeuing mic_work on remove

[Charles Keepax <ckeepax@opensource.cirrus.com>]

On Tue, Sep 22, 2026 at 11:06:41PM -0400, Myeonghun Pak wrote:
> --- a/sound/soc/codecs/wm8962.c
> +++ b/sound/soc/codecs/wm8962.c
> @@ -3115,7 +3115,7 @@ static void wm8962_mic_work(struct work_struct *work)
>  
>  	wm8962->mic_status = status;
>  
> -	snd_soc_jack_report(wm8962->jack, status,
> +	snd_soc_jack_report(READ_ONCE(wm8962->jack), status,
>  			    SND_JACK_MICROPHONE | SND_JACK_BTN_0);
>  
>  	snd_soc_component_update_bits(component, WM8962_MICINT_SOURCE_POL,
> @@ -3203,9 +3203,14 @@ static irqreturn_t wm8962_irq(int irq, void *data)
>  
>  		pm_wakeup_event(dev, 300);
>  
> -		queue_delayed_work(system_power_efficient_wq,
> -				   &wm8962->mic_work,
> -				   msecs_to_jiffies(250));
> +		/*
> +		 * mic_work reports this jack.  Removal clears it before
> +		 * synchronize_irq(), so do not queue once it is gone.
> +		 */
> +		if (READ_ONCE(wm8962->jack))

This feels a bit like its duplicating the mask check above, I
think it would be nicer to ensure that works as intended than
adding a second layer of filtering.

> +			queue_delayed_work(system_power_efficient_wq,
> +					   &wm8962->mic_work,
> +					   msecs_to_jiffies(250));
>  	}
>  
>  	pm_runtime_put(dev);
> @@ -3232,7 +3237,7 @@ int wm8962_mic_detect(struct snd_soc_component *component, struct snd_soc_jack *
>  	struct snd_soc_dapm_context *dapm = snd_soc_component_to_dapm(component);
>  	int irq_mask, enable;
>  
> -	wm8962->jack = jack;
> +	WRITE_ONCE(wm8962->jack, jack);
>  	if (jack) {
>  		irq_mask = 0;
>  		enable = WM8962_MICDET_ENA;
> @@ -3247,7 +3252,7 @@ int wm8962_mic_detect(struct snd_soc_component *component, struct snd_soc_jack *
>  			    WM8962_MICDET_ENA, enable);
>  
>  	/* Send an initial empty report */
> -	snd_soc_jack_report(wm8962->jack, 0,
> +	snd_soc_jack_report(jack, 0,
>  			    SND_JACK_MICROPHONE | SND_JACK_BTN_0);
>  
>  	snd_soc_dapm_mutex_lock(dapm);
> @@ -3594,6 +3599,15 @@ static void wm8962_remove(struct snd_soc_component *component)
>  {
>  	struct wm8962_priv *wm8962 = snd_soc_component_get_drvdata(component);
>  
> +	/*
> +	 * The IRQ stays registered for the I2C device, including across
> +	 * card unbind.  It is the only producer of mic_work.  Clear the
> +	 * jack first so a new handler does not queue, wait out a handler
> +	 * that already loaded the old pointer, then drain the work.
> +	 */
> +	WRITE_ONCE(wm8962->jack, NULL);

So probably calling wm8962_mic_detect() here. Although
granted that probably needs some small fixups as there are a
couple races, probably also makes sense to move the mic_work
sync in there too.

> +	if (wm8962->irq)
> +		synchronize_irq(wm8962->irq);
>  	cancel_delayed_work_sync(&wm8962->mic_work);
>  
>  	wm8962_free_gpio(component);
> base-commit: 238650ef6c7c7cca08e032527329424c9fbd70e5
> -- 
> 2.53.0

Thanks,
Charles