From: Shashank Maurya <shashank.maurya@oss.qualcomm.com>
To: Bjorn Andersson <andersson@kernel.org>
Cc: Konrad Dybcio <konradybcio@kernel.org>,
Rob Herring <robh@kernel.org>,
Krzysztof Kozlowski <krzk+dt@kernel.org>,
Conor Dooley <conor+dt@kernel.org>,
Florian Fainelli <florian.fainelli@broadcom.com>,
Broadcom internal kernel review list
<bcm-kernel-feedback-list@broadcom.com>,
linux-arm-msm@vger.kernel.org, devicetree@vger.kernel.org,
linux-kernel@vger.kernel.org,
linux-rpi-kernel@lists.infradead.org,
linux-arm-kernel@lists.infradead.org,
venkata.valluru@oss.qualcomm.com,
Jessica Zhang <jesszhan0024@gmail.com>
Subject: Re: [PATCH v2 0/2] arm64: dts: qcom: Add RPi 7-inch DSI panel overlays for Monaco/Lemans EVK
Date: Mon, 5 Oct 2026 11:41:49 +0530 [thread overview]
Message-ID: <asM/pR6C0RpmUR5y@hu-ssmaurya-hyd.qualcomm.com> (raw)
In-Reply-To: <arsp-8KPqD_skD5D@zenbook>
On Mon, Sep 28, 2026 at 10:05:20PM -0500, Bjorn Andersson wrote:
> On Thu, Sep 17, 2026 at 11:04:19AM +0530, Shashank Maurya wrote:
> > On Thu, Sep 10, 2026 at 02:35:41PM -0500, Bjorn Andersson wrote:
> > > On Mon, Sep 07, 2026 at 12:03:52PM +0530, Shashank Maurya wrote:
> > > > Add device tree overlays to enable support for the Raspberry Pi 7-inch
> > > > DSI touchscreen panel on Qualcomm Monaco and Lemans EVK platforms.
> > > >
> > > > The overlays configure the panel on the primary DSI interface using
> > > > a 2-lane DSI connection and instantiate the panel MCU on the
> > > > corresponding touchscreen I2C bus for each platform. The changes
> > > > allow the Raspberry Pi 7-inch display to be used as an external
> > > > display option on both EVKs without affecting the default platform
> > > > configuration.
> > > >
> > > > ---
> > > > To: Bjorn Andersson <andersson@kernel.org>
> > > > To: Konrad Dybcio <konradybcio@kernel.org>
> > > > To: Rob Herring <robh@kernel.org>
> > > > To: Krzysztof Kozlowski <krzk+dt@kernel.org>
> > > > To: Conor Dooley <conor+dt@kernel.org>
> > > > To: Florian Fainelli <florian.fainelli@broadcom.com>
> > > > To: Broadcom internal kernel review list <bcm-kernel-feedback-list@broadcom.com>
> > > > Cc: linux-arm-msm@vger.kernel.org
> > > > Cc: devicetree@vger.kernel.org
> > > > Cc: linux-kernel@vger.kernel.org
> > > > Cc: linux-rpi-kernel@lists.infradead.org
> > > > Cc: linux-arm-kernel@lists.infradead.org
> > > >
> > > > ---
> > > > Shashank Maurya (2):
> > > > arm64: dts: qcom: monaco-evk: Add Raspberry Pi 7-inch DSI panel overlay
> > > > arm64: dts: qcom: lemans-evk: Add Raspberry Pi 7-inch DSI panel overlay
> > > >
> > > > arch/arm64/boot/dts/qcom/Makefile | 4 ++
> > > > .../dts/qcom/lemans-evk-raspberrypi-dsi-7inch.dtso | 83 ++++++++++++++++++++++
> > > > .../dts/qcom/monaco-evk-raspberrypi-dsi-7inch.dtso | 82 +++++++++++++++++++++
> > > > 3 files changed, 169 insertions(+)
> > > > ---
> > > > base-commit: ed2647532a225739e86c7f236a2ce82764ec2772
> > > > change-id: 20260907-rpi_dts_overlay-58088ffce047
> > > > prerequisite-message-id: <20260907-rpi_reg-v2-0-0c59aa60d31f@oss.qualcomm.com>
> > >
> > > The two dts patches in this series clearly relates to those two
> > > regulator patches, which has received change requests.
> > >
> > > I would have sent the 4 patches together in a series, but as you didn't
> > > you sent this series with unmet dependencies.
> > >
> > > All I can do now is reject this series as well. Please send v2 once the
> > > driver changes has been merged and you have validated this again.
> > >
> > > Regards,
> > > Bjorn
> > >
> > > > prerequisite-patch-id: 5212bf185b35c36ed8857a67f29e60386d59ac60
> > > > prerequisite-patch-id: 056a90b913170106a6f8c1feb2366ee83c4375b9
> > > >
> > > > Best regards,
> > > > --
> > > > Shashank Maurya <shashank.maurya@oss.qualcomm.com>
> > > >
> >
> > Hi Bjorn,
> >
> > Thanks for the review.
> >
> > The regulator patches and DTS patches are targeting different maintainer trees
> > and therefore were developed and submitted from separate workspaces. While the
> > DTS changes depend on the regulator updates, the two sets of patches cannot
> > realistically be carried in a single series because they are reviewed and
> > merged through different paths.
> >
>
> In reality, Mark has shown many times that he's able to pick individual
> patches from a series and the 4 patches are better reviewed together.
>
> > I submitted the DTS series separately to start the review process in parallel,
> > but I understand your concern about the unresolved dependency.
> >
>
> Please send patches that are ready to be merged, and when you do make
> sure you send them in a way and at a time where they can be merged.
>
> Thanks,
> Bjorn
>
> > Regards,
> > Shashank
Sure, I was not aware that Mark can pick driver patch from here directly.
Driver patch is already in process, once driver patch is merged I'll post next
revision of this patch after valdiation.
Thanks,
Shashank.
prev parent reply other threads:[~2026-10-05 6:12 UTC|newest]
Thread overview: 15+ messages / expand[flat|nested] mbox.gz Atom feed top
2026-09-07 6:33 [PATCH v2 0/2] arm64: dts: qcom: Add RPi 7-inch DSI panel overlays for Monaco/Lemans EVK Shashank Maurya
2026-09-07 6:33 ` [PATCH v2 1/2] arm64: dts: qcom: monaco-evk: Add Raspberry Pi 7-inch DSI panel overlay Shashank Maurya
2026-09-07 6:47 ` sashiko-bot
2026-09-09 14:50 ` Konrad Dybcio
2026-09-22 6:18 ` Shashank Maurya
2026-09-09 14:51 ` Konrad Dybcio
2026-09-22 6:17 ` Shashank Maurya
2026-10-05 6:34 ` Dmitry Baryshkov
2026-10-08 18:32 ` Shashank Maurya
2026-09-07 6:33 ` [PATCH v2 2/2] arm64: dts: qcom: lemans-evk: " Shashank Maurya
2026-09-07 6:44 ` sashiko-bot
2026-09-10 19:35 ` [PATCH v2 0/2] arm64: dts: qcom: Add RPi 7-inch DSI panel overlays for Monaco/Lemans EVK Bjorn Andersson
2026-09-17 5:34 ` Shashank Maurya
2026-09-29 3:05 ` Bjorn Andersson
2026-10-05 6:11 ` Shashank Maurya [this message]
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=asM/pR6C0RpmUR5y@hu-ssmaurya-hyd.qualcomm.com \
--to=shashank.maurya@oss.qualcomm.com \
--cc=andersson@kernel.org \
--cc=bcm-kernel-feedback-list@broadcom.com \
--cc=conor+dt@kernel.org \
--cc=devicetree@vger.kernel.org \
--cc=florian.fainelli@broadcom.com \
--cc=jesszhan0024@gmail.com \
--cc=konradybcio@kernel.org \
--cc=krzk+dt@kernel.org \
--cc=linux-arm-kernel@lists.infradead.org \
--cc=linux-arm-msm@vger.kernel.org \
--cc=linux-kernel@vger.kernel.org \
--cc=linux-rpi-kernel@lists.infradead.org \
--cc=robh@kernel.org \
--cc=venkata.valluru@oss.qualcomm.com \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.