On Sun, Nov 15, 2026 at 12:06:28PM -0600, Tom Rini wrote: > On Sun, Nov 15, 2026 at 09:12:23AM -0800, George Kola wrote: > > > netspace_mini_v2_defconfig runs dhcp and activates netconsole in > > CONFIG_BOOTCOMMAND without setting ncip, exposing an unauthenticated > > UDP port 6666 console that accepts broadcast packets and drops to an > > interactive U-Boot shell over the local network. > > > > Remove dhcp and netconsole activation from CONFIG_BOOTCOMMAND and drop > > CONFIG_NETCONSOLE=y so the board boots directly from local USB or SATA > > storage by default. > > > > Fixes: 970bf8603b87 ("Convert CONFIG_USE_BOOTCOMMAND et al to Kconfig") > > Signed-off-by: George Kola > > This is feature working as intended, presumably. Yes, netconsole is enabled by default on purpose on the LaCie Kirkwood-based devices. When installing mainline U-Boot, you need a way to access the U-Boot console in order to configure the environment for booting the OS you are installing. The serial port is not always an option, since it requires opening the case and using a serial adapter (that you may not have). Here is a guide describing how to install and configure mainline U-Boot on these devices: https://lacie-nas.org/doku.php?id=uboot. Much of the procedure relies on netconsole being available. Note that you can disable netconsole support either at build time or at run time if/when you don't need it. But I think it is better to keep it enabled by default. Simon