[PATCH] net: bcmgenet: Don't set ID_MODE_DIS when not using RGMII

[Matthias Brugger <mbrugger@suse.com>]

On 20/02/2020 17:36, Nicolas Saenz Julienne wrote:
> As per Linux's driver, ID_MODE_DIS is only set when the PHY interface is
> RGMII. Don't enable it for the rest of setups.
> 
> This has been seen to misconfigure RPi4's PHY when booting Linux.
> 
> Signed-off-by: Nicolas Saenz Julienne <nsaenzjulienne@suse.de>
> ---
>  drivers/net/bcmgenet.c | 5 ++++-
>  1 file changed, 4 insertions(+), 1 deletion(-)
> 
> diff --git a/drivers/net/bcmgenet.c b/drivers/net/bcmgenet.c
> index 8f4848aec6..e971b556ac 100644
> --- a/drivers/net/bcmgenet.c
> +++ b/drivers/net/bcmgenet.c
> @@ -448,7 +448,10 @@ static int bcmgenet_adjust_link(struct bcmgenet_eth_priv *priv)
>  	}
>  
>  	clrsetbits_32(priv->mac_reg + EXT_RGMII_OOB_CTRL, OOB_DISABLE,
> -			RGMII_LINK | RGMII_MODE_EN | ID_MODE_DIS);
> +			RGMII_LINK | RGMII_MODE_EN);
> +
> +	if (phy_dev->interface == PHY_INTERFACE_MODE_RGMII)
> +		setbits_32(priv->mac_reg + EXT_RGMII_OOB_CTRL, ID_MODE_DIS);

Is this given because by different DTS? Shouldn't that be uniform on the RPi4?

BTW Joe, will you take patches for this driver through your branch? For now I
delegated it to me, but I'm fine either way.

Regards,
Matthias

>  
>  	writel(speed << CMD_SPEED_SHIFT, (priv->mac_reg + UMAC_CMD));
>  
>