From: bugzilla-daemon@bugzilla.kernel.org
To: linux-usb@vger.kernel.org
Subject: [Bug 206649] Lenovo C940 - USB3 disk not detected if connected after boot - no space for [mem size 0x00010000]
Date: Sun, 23 Feb 2020 22:32:39 +0000 [thread overview]
Message-ID: <bug-206649-208809-IO0eX4818h@https.bugzilla.kernel.org/> (raw)
In-Reply-To: <bug-206649-208809@https.bugzilla.kernel.org/>
https://bugzilla.kernel.org/show_bug.cgi?id=206649
A (email-ext@laposte.net) changed:
What |Removed |Added
----------------------------------------------------------------------------
Summary|Lenovo C940 - USB3 disk not |Lenovo C940 - USB3 disk not
|detected if connected after |detected if connected after
|boot |boot - no space for [mem
| |size 0x00010000]
--- Comment #2 from A (email-ext@laposte.net) ---
Here are some complementary dmesg log when plugin back the disk to thunderbolt
port on dock. From the log the following errors occured:
97.075649] usb 12-1: USB disconnect, device number 2
[ 97.076371] sd 1:0:0:0: [sda] Synchronizing SCSI cache
[ 97.092456] pcieport 0000:02:04.0: pciehp: Slot(0-2): Link Down
[ 97.092460] pcieport 0000:02:04.0: pciehp: Slot(0-2): Card not present
[ 97.092466] xhci_hcd 0000:07:00.0: PME# disabled
[ 97.092483] xhci_hcd 0000:07:00.0: remove, state 1
[ 97.092490] usb usb12: USB disconnect, device number 1
[ 97.187858] xhci_hcd 0000:07:00.0: xHCI host controller not responding,
assume dead
[ 97.281395] sd 1:0:0:0: [sda] Synchronize Cache(10) failed: Result:
hostbyte=DID_ERROR driverbyte=DRIVER_OK
[ 97.354815] xhci_hcd 0000:07:00.0: WARN Can't disable streams for endpoint
0x81, streams are being disabled already
[ 97.355682] xhci_hcd 0000:07:00.0: USB bus 12 deregistered
[ 97.355695] xhci_hcd 0000:07:00.0: remove, state 4
[ 97.355700] usb usb11: USB disconnect, device number 1
[ 97.355933] xhci_hcd 0000:07:00.0: Host halt failed, -19
[ 97.355937] xhci_hcd 0000:07:00.0: Host not accessible, reset failed.
[ 97.356817] xhci_hcd 0000:07:00.0: USB bus 11 deregistered
[ 97.357314] pci 0000:07:00.0: Removing from iommu group 3
[ 97.357379] pcieport 0000:02:04.0: saving config space at offset 0x0
(reading 0x15d38086)
[ 97.357384] pcieport 0000:02:04.0: saving config space at offset 0x4
(reading 0x100407)
[ 97.357388] pcieport 0000:02:04.0: saving config space at offset 0x8
(reading 0x6040002)
[ 97.357392] pcieport 0000:02:04.0: saving config space at offset 0xc
(reading 0x10010)
[ 97.357396] pcieport 0000:02:04.0: saving config space at offset 0x10
(reading 0x0)
[ 97.357400] pcieport 0000:02:04.0: saving config space at offset 0x14
(reading 0x0)
[ 97.357405] pcieport 0000:02:04.0: saving config space at offset 0x18
(reading 0x2c0702)
[ 97.357409] pcieport 0000:02:04.0: saving config space at offset 0x1c
(reading 0x1f1)
[ 97.357413] pcieport 0000:02:04.0: saving config space at offset 0x20
(reading 0x5fd05400)
[ 97.357418] pcieport 0000:02:04.0: saving config space at offset 0x24
(reading 0x1bf10001)
[ 97.357422] pcieport 0000:02:04.0: saving config space at offset 0x28
(reading 0x60)
[ 97.357426] pcieport 0000:02:04.0: saving config space at offset 0x2c
(reading 0x60)
[ 97.357430] pcieport 0000:02:04.0: saving config space at offset 0x30
(reading 0x0)
[ 97.357434] pcieport 0000:02:04.0: saving config space at offset 0x34
(reading 0x80)
[ 97.357437] pcieport 0000:02:04.0: saving config space at offset 0x38
(reading 0x0)
[ 97.357441] pcieport 0000:02:04.0: saving config space at offset 0x3c
(reading 0x201ff)
[ 97.357521] pcieport 0000:02:04.0: PME# enabled
[ 134.658112] pcieport 0000:02:04.0: restoring config space at offset 0x2c
(was 0x60, writing 0x60)
[ 134.658120] pcieport 0000:02:04.0: restoring config space at offset 0x28
(was 0x60, writing 0x60)
[ 134.658127] pcieport 0000:02:04.0: restoring config space at offset 0x24
(was 0x1bf10001, writing 0x1bf10001)
[ 134.658239] pcieport 0000:02:04.0: PME# disabled
[ 134.658289] pcieport 0000:02:04.0: pciehp: Slot(0-2): Card present
[ 134.658291] pcieport 0000:02:04.0: pciehp: Slot(0-2): Link Up
[ 134.658304] pcieport 0000:00:07.0: PME: Spurious native interrupt!
[ 134.791395] pci 0000:07:00.0: [8086:15d4] type 00 class 0x0c0330
[ 134.791453] pci 0000:07:00.0: reg 0x10: [mem 0x00000000-0x0000ffff]
[ 134.791548] pci 0000:07:00.0: enabling Extended Tags
[ 134.791760] pci 0000:07:00.0: supports D1 D2
[ 134.791762] pci 0000:07:00.0: PME# supported from D0 D1 D2 D3hot D3cold
[ 134.791771] pci 0000:07:00.0: PME# disabled
[ 134.791897] pci 0000:07:00.0: 8.000 Gb/s available PCIe bandwidth, limited
by 2.5 GT/s x4 link at 0000:00:07.0 (capable of 31.504 Gb/s with 8 GT/s x4
link)
[ 134.792031] pci 0000:07:00.0: Adding to iommu group 3
[ 134.792033] pci 0000:07:00.0: DMAR: Use Intel IOMMU bounce page dma_ops
[ 134.792144] pcieport 0000:02:04.0: ASPM: current common clock configuration
is broken, reconfiguring
[ 134.792214] pcieport 0000:02:04.0: bridge window [io 0x1000-0x0fff] to [bus
07-2c] add_size 1000
[ 134.792222] pcieport 0000:02:04.0: BAR 13: no space for [io size 0x1000]
[ 134.792224] pcieport 0000:02:04.0: BAR 13: failed to assign [io size
0x1000]
[ 134.792227] pcieport 0000:02:04.0: BAR 13: no space for [io size 0x1000]
[ 134.792229] pcieport 0000:02:04.0: BAR 13: failed to assign [io size
0x1000]
[ 134.792234] pci 0000:07:00.0: BAR 0: no space for [mem size 0x00010000]
[ 134.792236] pci 0000:07:00.0: BAR 0: failed to assign [mem size 0x00010000]
[ 134.792239] pcieport 0000:02:04.0: PCI bridge to [bus 07-2c]
[ 134.792249] pcieport 0000:02:04.0: bridge window [mem
0x54000000-0x5fdfffff]
[ 134.792256] pcieport 0000:02:04.0: bridge window [mem
0x6000000000-0x601bffffff 64bit pref]
[ 134.792266] PCI: No. 2 try to assign unassigned res
[ 134.792269] pcieport 0000:02:04.0: resource 14 [mem 0x54000000-0x5fdfffff]
released
[ 134.792271] pcieport 0000:02:04.0: PCI bridge to [bus 07-2c]
[ 134.792278] pcieport 0000:02:04.0: bridge window [io 0x1000-0x0fff] to [bus
07-2c] add_size 1000
[ 134.792284] pcieport 0000:02:04.0: BAR 14: no space for [mem size
0x0be00000]
[ 134.792286] pcieport 0000:02:04.0: BAR 14: failed to assign [mem size
0x0be00000]
[ 134.792289] pcieport 0000:02:04.0: BAR 13: no space for [io size 0x1000]
[ 134.792290] pcieport 0000:02:04.0: BAR 13: failed to assign [io size
0x1000]
[ 134.792294] pcieport 0000:02:04.0: BAR 14: no space for [mem size
0x0be00000]
[ 134.792295] pcieport 0000:02:04.0: BAR 14: failed to assign [mem size
0x0be00000]
[ 134.792298] pcieport 0000:02:04.0: BAR 13: no space for [io size 0x1000]
[ 134.792299] pcieport 0000:02:04.0: BAR 13: failed to assign [io size
0x1000]
[ 134.792302] pci 0000:07:00.0: BAR 0: no space for [mem size 0x00010000]
[ 134.792303] pci 0000:07:00.0: BAR 0: failed to assign [mem size 0x00010000]
[ 134.792305] pcieport 0000:02:04.0: PCI bridge to [bus 07-2c]
[ 134.792318] pcieport 0000:02:04.0: bridge window [mem
0x6000000000-0x601bffffff 64bit pref]
[ 134.793120] xhci_hcd 0000:07:00.0: init 0000:07:00.0 fail, -16
[ 134.793131] xhci_hcd: probe of 0000:07:00.0 failed with error -16
[ 279.153557] audit: type=1101 audit(1582476267.943:111): pid=2448
--
You are receiving this mail because:
You are watching the assignee of the bug.
next prev parent reply other threads:[~2020-02-23 22:32 UTC|newest]
Thread overview: 5+ messages / expand[flat|nested] mbox.gz Atom feed top
2020-02-23 22:14 [Bug 206649] New: Lenovo C940 - USB3 disk not detected if connected after boot bugzilla-daemon
2020-02-23 22:15 ` [Bug 206649] " bugzilla-daemon
2020-02-23 22:32 ` bugzilla-daemon [this message]
2020-02-23 22:33 ` [Bug 206649] Lenovo C940 - USB3 disk not detected if connected after boot - no space for [mem size 0x00010000] bugzilla-daemon
2020-02-26 22:10 ` bugzilla-daemon
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=bug-206649-208809-IO0eX4818h@https.bugzilla.kernel.org/ \
--to=bugzilla-daemon@bugzilla.kernel.org \
--cc=linux-usb@vger.kernel.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.