Re: [PATCH V5 2/3] arm64: dts: qcom: monaco-evk: Enable SDHCI for SD Card via overlay

[Konrad Dybcio <konrad.dybcio@oss.qualcomm.com>]

On 8/26/26 1:24 PM, Monish Chunara wrote:
> The monaco EVK board supports either eMMC or SD-card, but only one can
> be active at a time.
> 
> Make the base monaco-evk.dtsi storage-agnostic by removing eMMC-specific
> configuration from it. This allows storage media selection to be handled
> through device tree overlays.
> 
> Introduce an SD card overlay that enables the SD Host Controller
> Interface (SDHCI) for SD-based storage on the monaco EVK board.
> 
> Signed-off-by: Monish Chunara <monish.chunara@oss.qualcomm.com>
> ---

[...]

> +&sdhc1_opp_table {
> +	opp-100000000 {
> +		opp-hz = /bits/ 64 <100000000>;
> +		required-opps = <&rpmhpd_opp_low_svs>;
> +	};
> +
> +	opp-202000000 {
> +		opp-hz = /bits/ 64 <202000000>;
> +		required-opps = <&rpmhpd_opp_svs_l1>;
> +	};
> +};

This only adds to the existing table, not removing the existing
entries

Based on the previous discussions at

https://lore.kernel.org/linux-arm-msm/de10ed05-a0fc-4f84-83ea-8810270ff2d6@oss.qualcomm.com/

I'm not sure this is intended

Konrad