Address mapping PPC 405

["P. Sadik" <psadik@gmail.com>]

Hello,

  I have a question on how PPC addressing works. I am familiar with
the MIPS architecture and new to PPC.

  On MIPS, there are KUSEG (0x0000_0000 to 0x07FF_FFFF)
which is always translated using TLB. Then there are two
un-translated areas KSEG0 (0x8000_0000 which is cached)
and KSEG1 (0xA000_0000).

  Hence, the kernel is compiled with .text at 0x8000_0000. For kernel
itself, the TLB is never consulted. All the local peripherals will be mappe=
d to=20
0xA000_0000. That means, from kernel, if I have to access a register of any=
=20
peripheral, I can use the un-mapped address and everything will work.

 On PPC I see that, the kernel .text is at 0xC000_0000. Is it a=20
translated address? If it is, for running kernel code, the CPU has to
consult the TLB always?

 Another question is regarding addressing local peripherals. I am using
an ML310 board from Xilinx and it has DDR mapped to 0x0000_0000
to 0x0FFF_FFFF (256 MB). Now, I need to add an IP to the PLB.
For that, I am thinking of using 0x2000_0000 to 0x2000_0FFF.
Now, my driver need to access the registers within the above region.
How will I do that? It is an I/O, hence should I use ioremap, or can
I access it directly? What role cache will play in this case?

 The third question is, can I use de-referencing of address. Is it O.K
to use pointers to access the registers, or do I have to use read/write
variants?=20

  I would appreciate a lot if you could give some insight into this. Any
pointers or reading materials will be very helpful.

Thanks and regards,

Sadik.