From mboxrd@z Thu Jan 1 00:00:00 1970 From: James Stafford Subject: Re: [PATCH] Envy24HT Date: Wed, 04 Dec 2002 12:54:54 +0000 Sender: alsa-devel-admin@lists.sourceforge.net Message-ID: References: Mime-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Return-path: In-Reply-To: Errors-To: alsa-devel-admin@lists.sourceforge.net List-Help: List-Post: List-Subscribe: , List-Unsubscribe: , List-Archive: To: Jaroslav Kysela Cc: "alsa-devel@lists.sourceforge.net" List-Id: alsa-devel@alsa-project.org At 19:06 03/12/02 +0100, you wrote: >I think that the default should be left in the AC97 code and write the >appropriate configuration after snd_ac97_mixer() call when you detect your >hardware and VT1616 codec. I have added a build_controls function in the amp.c file which sets the relavent ac97 register. Is this the correct way to do this? >We send data in this order: channel0,1 = front; channel2,3 = rear; >channel4,5 = center/lfe ; if your hardware has swapped some stereo paths, >you need to swap channels in software - see >alsa-lib/src/conf/cards/ICH.conf - ICH.pcm.surround51.0 {} section Once I have a conf file, what do I do with it and how do I use it? As a test, I added pcm.ice1724 { type plug ttable.0.0 1 ttable.1.1 1 ttable.2.4 1 ttable.3.5 1 ttable.4.2 1 ttable.5.3 1 slave.pcm { type hw card 0 device 0 } } to my ~/.asoundrc file. The channels were then routed correctly when using the "ice1724" device. ------------------------------------------------------- This SF.net email is sponsored by: Microsoft Visual Studio.NET comprehensive development tool, built to increase your productivity. Try a free online hosted session at: http://ads.sourceforge.net/cgi-bin/redirect.pl?micr0003en