Re: [LARTC] Shape and Bridge which Interface to use?

From: "Chris K Ellsworth" <cke@highlandshighspeed.net>
To: lartc@vger.kernel.org
Subject: Re: [LARTC] Shape and Bridge which Interface to use?
Date: Tue, 11 Jun 2002 18:41:44 +0000	[thread overview]
Message-ID: <marc-lartc-102382095913469@msgid-missing> (raw)
In-Reply-To: <marc-lartc-102378492009591@msgid-missing>

Have you patched your kernel to allow access the bridge packets?
http://bridge.sourceforge.net

and also note that from what i have learned you had to use iptables,
prerouting mangle table, to mark the packets then use tc filiters to put the
packets into a qdics for shapping. and you could only shap out going traffic

you can also check out the bridges list serve @ bridge@math.leidenuniv.nl
they are a good source for bridging problems

Chris
----- Original Message -----
From: "ALBRECHT, BENJAMIN" <BENJAMIN.ALBRECHT@de.thalesgroup.com>
To: <lartc@mailman.ds9a.nl>
Sent: Tuesday, June 11, 2002 1:35 AM
Subject: [LARTC] Shape and Bridge which Interface to use?

hi list,

if tested linux bridging with the tc commands. but the kernel did not
recognized my commands. the commands are from some howto´s. the should be
correct. must i use the "bridge-interface"?

not eth0 and eth1?  anyone some progress report to this situation?

thank you

greetings benny

--
Mit freundlichen Grüßen / Best regards

THALES COMMUNICATIONS GmbH
Benjamin Albrecht
Dept.: DP/CIT
Tel.:  +49-7231-15-3962
Fax.:  +49-7231-15-3813
eMail: Benjamin.Albrecht@de.thalesgroup.com

_______________________________________________
LARTC mailing list / LARTC@mailman.ds9a.nl
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

_______________________________________________
LARTC mailing list / LARTC@mailman.ds9a.nl
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/