From mboxrd@z Thu Jan 1 00:00:00 1970 From: Bogdan Coman Date: Tue, 04 Mar 2003 09:43:25 +0000 Subject: Re: [LARTC] QoS on bridge device Message-Id: List-Id: References: In-Reply-To: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: lartc@vger.kernel.org The shaping is done on eth0 and eth1. There is also a patch that allows you to match packets that are passing the bridge with iptables. Br0 is used only for trafic that is for the bridge. Eg. a machine has a route through the ip of br0. Bogdan Coman On Tue, 2003-03-04 at 10:58, Abraham van der Merwe wrote: > Hi! > > Usually if you have a machine and traffic passes through it: > > +-----+ > eth0| QoS | > -------------| box |------------- > | |eth1 > +-----+ > > You can shape outgoing traffic on eth0 and eth1 effectively shaping both > incoming/outgoing traffic. > > With bridging and above setup you only have a single device br0 - my > question is whether you can shape both incoming/outgoing traffic on this > device (i would presume it is not possible) or do you need to redirect > traffic passing through br0 to imq0 and do shaping on outgoing traffic on > both br0 and imq0? > > -- > > Regards > Abraham > > If you're not part of the solution, you're part of the precipitate. > > ___________________________________________________ > Abraham vd Merwe [ZR1BBQ] - Frogfoot Networks > P.O. Box 3472, Matieland, Stellenbosch, 7602 > Cell: +27 82 565 4451 Http: http://www.frogfoot.net/ > Email: abz@frogfoot.net > _______________________________________________ LARTC mailing list / LARTC@mailman.ds9a.nl http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/