From mboxrd@z Thu Jan 1 00:00:00 1970 From: Craig J Howard Date: Fri, 28 Mar 2003 06:17:05 +0000 Subject: [LARTC] connecting IMQ to different interfaces Message-Id: List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: lartc@vger.kernel.org Ok, I'm pretty new to this stuff, so I hope this question doesn't appear stupid: How do I connect an IMQ to different network interfaces? eg...say I want to control OUTGOING traffic normally on 3 different interfaces: tc qdisc add dev "eth0" root handle 1: htb default 1 tc class add dev "eth0" parent 1: classid 1:1 htb rate 200kbit ceil 350kbit prio 2 tc qdisc add dev "eth1" root handle 1: htb default 1 tc class add dev "eth1" parent 1: classid 1:1 htb rate 200kbit ceil 350kbit prio 2 tc qdisc add dev "eth2" root handle 1: htb default 1 tc class add dev "eth2" parent 1: classid 1:1 htb rate 200kbit ceil 350kbit prio 2 now I want to control INCOMING traffic to the three different interfaces with IMQ: tc qdisc add dev "imq0" root handle 1: htb default 1 tc class add dev "imq0" parent 1: classid 1:1 htb rate 2000kbit prio 3 iptables -t mangle -A PREROUTING -i eth0 -j IMQ --todev 0 ip link set "imq0" up tc qdisc add dev "imq1" root handle 1: htb default 1 tc class add dev "imq1" parent 1: classid 1:1 htb rate 2000kbit prio 3 iptables -t mangle -A PREROUTING -i eth1 -j IMQ --todev 1 ip link set "imq1" up Now how do I apply it to the third interface? I've run out of imq's! Thanks guys craig _______________________________________________ LARTC mailing list / LARTC@mailman.ds9a.nl http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/