From mboxrd@z Thu Jan 1 00:00:00 1970 From: "Tushar Gupta" Date: Sun, 20 Apr 2003 10:53:45 +0000 Subject: RE: [LARTC] Rshaper-2.01 issue with Linux8.0 Message-Id: List-Id: References: In-Reply-To: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: lartc@vger.kernel.org I have looked at tc and information on www.docum.org earlier too. I have a feeling that it is going to take a lot of time before I become comfortable with tc/htb/cbq, and understand all its nuiances. I am looking forward to some quick and maybe not so good solution as directly working with tc. With rshaper I just needed to specify IP and amount of max bandwidth I want to allocate to the host, and I am up and running. Tushar -----Original Message----- From: lartc-admin@mailman.ds9a.nl [mailto:lartc-admin@mailman.ds9a.nl] On Behalf Of Stef Coene Sent: Saturday, April 19, 2003 5:36 PM To: Tushar Gupta; lartc@mailman.ds9a.nl Subject: Re: [LARTC] Rshaper-2.01 issue with Linux8.0 On Saturday 19 April 2003 13:42, Tushar Gupta wrote: > I am facing problem with running rshaper-2.01 with Linux 8.0 version > (redhat). It used to run fine with Linux7.1 version. > > Is there any update on rshaper available for 8.0 I don't know. But if you want to shape traffic, you better use the tc command line to configure a htb or cbq setup. This is more powerfull then rshaper. More info about tc can be found on www.lartc.org and www.docum.org. Stef -- stef.coene@docum.org "Using Linux as bandwidth manager" http://www.docum.org/ #lartc @ irc.oftc.net _______________________________________________ LARTC mailing list / LARTC@mailman.ds9a.nl http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/ _______________________________________________ LARTC mailing list / LARTC@mailman.ds9a.nl http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/