From mboxrd@z Thu Jan 1 00:00:00 1970 From: "hare ram" Date: Mon, 21 Apr 2003 09:42:44 +0000 Subject: Re: [LARTC] IMQ Setup-- first example Message-Id: List-Id: References: In-Reply-To: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: lartc@vger.kernel.org Could some one respond to this post please hare > Hi all > > thanks to Mr Devik , Mr Stef, Mr Patrick > > At last iam able to successfully compiles with RH 9.0 with Iptables 1.2.8 > with IMQ > not all are working fine with out any Errors, and iam able to see the > traffic on IMQ Interface, when i mark the packets > > on test base i have made a small example below, need confirmation > > below example, iam trying to control up+down= 128kbps for the ip of x.x.x19 > > when try to download from internet, i was getting approximately 18.3Kil0 > bytes > > when i try up load the same time, to one of my local FTP server, which is > located out side my LAN > iam able to transfer the rate of 14Kilo Bytes, and the download speed > decreased to 4+ kilo bytes > > so i assume my setup is running perfectly both the ways, but i did not use > postrouting..... i have used only prerouting... > > my setup is like this > > ----- FTP Server > LAPTOP--Switch--Eth1(Bridge)Eth0---Switch ---| > > -----Internet > > > > modprobe imq numdevs=1 > > tc qdisc add dev imq0 handle 1: root htb default 1 > tc class add dev imq0 parent 1: classid 1:1 htb rate 1mbit > > tc qdisc add dev imq0 parent 1:1 handle 10: htb default 5 > tc class add dev imq0 parent 10: classid 10:1 htb rate 128kbit burst 3k > prio 1 > tc class add dev imq0 parent 10: classid 10:2 htb rate 128kbit burst 3k > prio 2 > tc class add dev imq0 parent 10: classid 10:5 htb rate 1mbit prio 3 > > tc qdisc add dev imq0 parent 10:1 handle 21:0 sfq > tc qdisc add dev imq0 parent 10:2 handle 22:0 sfq > tc qdisc add dev imq0 parent 10:5 handle 23:0 sfq > > tc filter add dev imq0 protocol ip pref 1 parent 10: handle 1 fw classid > 10:1 > tc filter add dev imq0 protocol ip pref 2 parent 10: handle 2 fw classid > 10:2 > > iptables -t mangle -A PREROUTING -i eth1 -j IMQ --todev 0 > iptables -t mangle -A PREROUTING -i eth1 -s x.x.x.19 -j MARK --set-mark 1 > > ip link set imq0 up > > > so is this setup correct, i need to make some more correction, please > suggest > > thanks > hare > > > _______________________________________________ > LARTC mailing list / LARTC@mailman.ds9a.nl > http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/ > _______________________________________________ LARTC mailing list / LARTC@mailman.ds9a.nl http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/