From mboxrd@z Thu Jan 1 00:00:00 1970 From: Stef Coene Date: Fri, 02 May 2003 17:12:43 +0000 Subject: Re: [LARTC] Wonder shaper between two ethernet links Message-Id: List-Id: References: In-Reply-To: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: lartc@vger.kernel.org On Thursday 01 May 2003 19:28, Mel Gorman wrote: > This is quiet possibly a simple and obvious question but I'm only getting > to grips with traffic shaping and filtering. I have a firewall with two > ethernet connections, one internal (eth0) and one external to a modem > (eth1). I'm trying to set up a filter on eth1 that will give interactive > traffic high priority outgoing and limit downloads to a fixed rate. This > is what I thought wondershaper was meant to do. > > However, on the last line of the script > > tc filter add dev $DEV parent ffff: protocol ip prio 50 u32 match ip src \ > 0.0.0.0/0 police rate ${DOWNLINK}kbit burst 10k drop flowid :1 > > All traffic will be dropped and I can't figure out why. Any help would be > appreciated or at least a pointer to the right section to start reading. > Rooting through the archives didn't seem to have an obvious answer and > neither did the HOWTO but that is likely to be my pooor understanding more > than anything else I can remember me a problem with this line. Do you have ingress support in your kernel? Stef -- stef.coene@docum.org "Using Linux as bandwidth manager" http://www.docum.org/ #lartc @ irc.oftc.net _______________________________________________ LARTC mailing list / LARTC@mailman.ds9a.nl http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/