From mboxrd@z Thu Jan 1 00:00:00 1970 From: Stef Coene Date: Thu, 26 Apr 2001 06:20:38 +0000 Subject: Re: [LARTC] TC on bridge Message-Id: List-Id: References: In-Reply-To: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: lartc@vger.kernel.org I completed the diagram : > [Mail Server1] ---\ eth0 > [www Server2] --- [Bridge Linux] --- [Cisco router] > [xxx Server3] ---/ eth1 - Incoming traffic : You have to use eth0 (traffic goes out on NIC eth0) and you have the use the destination ip-address to split the traffic (filter u32 or filter fw+firewall-rules) - Outgoing traffic : For this you have to use eth1 and you can use the source ip-address to filter the traffic. I tested it, so I know it's working. -- Staf More QOS info : http://users.belgacom.net/staf/ fabian wrote: > > Hello lartc, > I have a linux bridge between my mail server and the cisco router > (internet).. > The linux bridge can shape the inconmig mail ? ( mail server run > windows2000) or outgoing www traffic? > I read some howto's but only talk about linux router (not bridge). > > Diagram: > > [Mail Server1] ---\ > [www Server2] --- [Bridge Linux] --- [Cisco router] > [xxx Server3] ---/ > > Best regards, > fabian mailto:fabian@catamarca.rffdc.edu.ar > > _______________________________________________ > LARTC mailing list / LARTC@mailman.ds9a.nl > http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://ds9a.nl/2.4Routing/ _______________________________________________ LARTC mailing list / LARTC@mailman.ds9a.nl http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://ds9a.nl/2.4Routing/