From mboxrd@z Thu Jan 1 00:00:00 1970 From: Stef Coene Date: Mon, 21 May 2001 09:15:46 +0000 Subject: Re: [LARTC] How to specify bandwidth Message-Id: List-Id: References: In-Reply-To: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: lartc@vger.kernel.org Solution : - add CBQ root qdisc with bandwidth 100mbps - add BOUNDED class with bandwidth 100mbps, rate 320kbps - add CBQ qdisc with bandwidth 320kbps, rate 320Kbps - add al the other classes to second qdisc For LAN : I suggest to do the same. Stef Jaco van der Schyff wrote: > > Greetings, > > I have a quick question as how to specify bandwith on my eth0 device. > > I have a cisco router connected to eth0, and the cisco router is > connected to our ISP via a 320Kbps link. > > When I specify the bandwith in tc, do I specify it as 320Kbps (the > bandwidth of the internet link) or as 100Mbps (the bandwidth > available on eth0) > > And the same question as to the bandwidth on eth1 (link to lan). > Should that also be 320kbps or 100mbps? > > Any help would be greatly appreciated. > > > - Jaco van der Schyff > jvds@netgroup.co.za > > _______________________________________________ > LARTC mailing list / LARTC@mailman.ds9a.nl > http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://ds9a.nl/2.4Routing/ -- Stef More QOS info : http://users.belgacom.net/staf/ _______________________________________________ LARTC mailing list / LARTC@mailman.ds9a.nl http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://ds9a.nl/2.4Routing/