From mboxrd@z Thu Jan 1 00:00:00 1970 From: Rich Sahlender Date: Thu, 29 Oct 1998 14:17:26 +0000 Subject: sparc64 mt race? Message-Id: List-Id: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: ultralinux@vger.kernel.org I'm not sure if this is a kernel, scsi, or 32 .vs. 64 bit issue... Using the latest 2.1.126 from vger cvs with ultrapenguin-1.0.9 on an Ultra1, a simple "mt -f /dev/st0 off" to unload a tape sends the cpu to 100%. Running processes continue but cannot terminate, new processes will not start. dmesg shows: esp0: IRQ 3,7e0 SCSI ID 7 Clock 40 MHz CCF=8 Time-Out 167 NCR53C9XF(espfast) detected esp0: FAST chip is fasHME (family, version=5) ESP: Total of 1 ESP hosts found, 1 actually in use. scsi0 : Sparc ESP366-HME scsi : 1 host. Vendor: SEAGATE Model: ST32171W SUN2.1G Rev: 7462 Type: Direct-Access ANSI SCSI revision: 02 Detected scsi disk sda at scsi0, channel 0, id 0, lun 0 Vendor: EXABYTE Model: EXB-85008SQANXBA Rev: 07J0 Type: Sequential-Access ANSI SCSI revision: 02 Detected scsi tape st0 at scsi0, channel 0, id 4, lun 0 Vendor: TOSHIBA Model: XM5701TASUN12XCD Rev: 0997 Type: CD-ROM ANSI SCSI revision: 02 Detected scsi CD-ROM sr0 at scsi0, channel 0, id 6, lun 0 scsi : detected 1 SCSI tape 1 SCSI cdrom 1 SCSI disk total. esp0: Disabling sync for buggy Toshiba CDROM. esp0: Disabling DISCONNECT for target 6 lun 0 esp0: target 6 asynchronous Uniform CDROM driver Revision: 2.14 esp0: Disabling DISCONNECT for target 0 lun 0 esp0: 16 byte WIDE transfers enabled for target 0. esp0: target 0 [period 100ns offset 15 20.00MHz FAST-WIDE SCSI-II] SCSI device sda: hdwr sector= 512 bytes. Sectors= 4157201 [2029 MB] [2.0 GB] sunhme.c:v1.2 10/Oct/96 David S. Miller (davem@caipfs.rutgers.edu) eth0: HAPPY MEAL (SBUS) 10/100baseT Ethernet 08:00:20:8d:21:cd Partition check: sda: sda1 sda2 sda3 sda4 sda6 sda7 sda8 VFS: Mounted root (ext2 filesystem) readonly. Adding Swap: 151224k swap-space (priority -1) Swansea University Computer Society IPX 0.38 for NET3.037 IPX Portions Copyright (c) 1995 Caldera, Inc. eth0: Link is up using internal transceiver at 100Mb/s, Full Duplex. sunmouse: Successfully adjusted to 1200 baud. Nothing unusual there nor in syslog. Is there anything else I can provide to help? Regards, Rich