From mboxrd@z Thu Jan 1 00:00:00 1970 From: Jakub Jelinek Date: Fri, 17 Sep 1999 22:32:39 +0000 Subject: Re: Install options on AXi Message-Id: List-Id: References: In-Reply-To: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: ultralinux@vger.kernel.org On Fri, Sep 17, 1999 at 03:43:22PM -0400, Brent Jay Thorpe wrote: > All, > > I have to make a customer presentation about install options with Linux > on AXi (CDROM, Floppy, Network.) I have been doing some homework in > making the "slideware" and found that you could get the initial boot > loader from a floppy device (as well as tftp.) In following the > instructions on creating the floppy, I found that my system does not > recognize the floppy device as a valid block device. In other words, it > cannot see the floppy device at all. Have you tried /dev/fd0 or /dev/fd1 as the device? Some AX and AXi boxes have these swapped, so even if you only have one floppy, it might be /dev/fd1. See bootup dmesg which one do you have. (It is a hardware issue). > I also found out that it does not > recognize the printer port (lp0) either. Anyone know what is the > correct device for both the floppy and printer on an AXi? Have you loaded all the required modules for the parallel port? You need probably parport_ax, parport and lp modules. Cheers, Jakub ___________________________________________________________________ Jakub Jelinek | jj@sunsite.mff.cuni.cz | http://sunsite.mff.cuni.cz Administrator of SunSITE Czech Republic, MFF, Charles University ___________________________________________________________________ UltraLinux | http://ultra.linux.cz/ | http://ultra.penguin.cz/ Linux version 2.3.18 on a sparc64 machine (1343.49 BogoMips) ___________________________________________________________________