From mboxrd@z Thu Jan 1 00:00:00 1970 From: Florian Lohoff Date: Tue, 21 Sep 1999 12:27:06 +0000 Subject: Re: RAID is now working... Message-Id: List-Id: References: In-Reply-To: MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: ultralinux@vger.kernel.org On Sun, Sep 19, 1999 at 07:40:59PM -0400, David Cooley wrote: > > Mine started doing that on the second PTI card I installed... Got looking > at the boot messages where it first detects the cards... My old one > (working fine) is detected as ultra scsi... the "new one" is detected as > fast scsi... Both cards have the same SUN part number on them, but the > "new" one has ver 1.71 on the sticker on the prom on the board, and the > "old" one (the one that works all the time) has 1.73 on it. The code read > by the kernel driver in the boards is 1.21 for the one that fails and 1.25 > on the good one. All 3 cards i have build into my SparcServer 5 are Version 1.21 (by label on the chips and also on detection) Probably this all is an Firmware problem. BTW: Mine are all detected as Fast-Wide controllers Sep 12 15:37:00 puke kernel: qpti0: IRQ 53 SCSI ID 7 (Firmware 1.21 95/05/18) [Fast Wide, using single ended interface] Sep 12 15:37:00 puke kernel: qpti1: IRQ 53 SCSI ID 7 (Firmware 1.21 95/05/18) [Fast Wide, using single ended interface] Sep 12 15:37:00 puke kernel: qpti2: IRQ 53 SCSI ID 7 (Firmware 1.21 95/05/18) [Fast Wide, using single ended interface] Sep 12 15:37:00 puke kernel: QPTI: Total of 3 PTI Qlogic/ISP hosts found, 3 actually in use. So - Which way to go for new Firmware ? Flo -- Florian Lohoff flo@rfc822.org +49-5241-470566 ... The failure can be random; however, when it does occur, it is catastrophic and is repeatable ... Cisco Field Notice