From: "Roman Jarosz" <roman.jarosz@gmail.com>
To: linux-dvb@linuxtv.org
Subject: [linux-dvb] DVB-S Channel searching problem
Date: Sat, 03 Jan 2009 17:42:38 +0100 [thread overview]
Message-ID: <op.um6wpcvirj95b0@localhost> (raw)
Hi,
I have a problem with DVB-S channel searching, the scan command doesn't find all channels in Linux on Astra 19.2E.
It works in Windows.
For instance the scan doesn't find RTL2, but if I add to channels.conf
RTL2:12187:h:0:27500:166:128:12020
then szap -r works correctly.
I have TeVii S460 DVB-S/S2.
Linux kernel 2.6.28.
Can anybody help me to find out why the scan doesn't work correctly.
I've compiled kernel from source so I can apply patches or change its settings.
Regards,
Roman
lspci:
00:09.0 Multimedia video controller: Conexant CX23880/1/2/3 PCI Video and Audio Decoder (rev 05)
Subsystem: Unknown device d460:9022
Flags: bus master, medium devsel, latency 32, IRQ 10
Memory at e8000000 (32-bit, non-prefetchable) [size=16M]
Capabilities: [44] Vital Product Data
Capabilities: [4c] Power Management version 2
00:09.2 Multimedia controller: Conexant CX23880/1/2/3 PCI Video and Audio Decoder [MPEG Port] (rev 05)
Subsystem: Unknown device d460:9022
Flags: bus master, medium devsel, latency 32, IRQ 10
Memory at e9000000 (32-bit, non-prefetchable) [size=16M]
Capabilities: [4c] Power Management version 2
This is part of dmesg:
cx8800 0000:00:09.0: PCI INT A -> Link[LNKB] -> GSI 10 (level, low) -> IRQ 10
cx88[0]: quirk: PCIPCI_NATOMA -- set TBFX
cx88[0]: subsystem: d460:9022, board: TeVii S460 DVB-S/S2 [card=70,autodetected], frontend(s): 1
cx88[0]: TV tuner type -1, Radio tuner type -1
cx88[0]/0: found at 0000:00:09.0, rev: 5, irq: 10, latency: 32, mmio: 0xe8000000
cx88[0]/0: registered device video0 [v4l2]
cx88[0]/0: registered device vbi0
Linux agpgart interface v0.103
agpgart-intel 0000:00:00.0: Intel 440BX Chipset
agpgart-intel 0000:00:00.0: AGP aperture is 32M @ 0xe4000000
EXT3 FS on sda1, internal journal
Adding 1020088k swap on /dev/sda5. Priority:-1 extents:1 across:1020088k
kjournald starting. Commit interval 5 seconds
EXT3 FS on sda6, internal journal
EXT3-fs: mounted filesystem with ordered data mode.
loop: module loaded
eth2: link up, 100Mbps, full-duplex, lpa 0xC5E1
warning: `proftpd' uses 32-bit capabilities (legacy support in use)
NFSD: Using /var/lib/nfs/v4recovery as the NFSv4 state recovery directory
NFSD: starting 90-second grace period
cx88/2: cx2388x MPEG-TS Driver Manager version 0.0.6 loaded
cx88[0]/2: cx2388x 8802 Driver Manager
cx88-mpeg driver manager 0000:00:09.2: PCI INT A -> Link[LNKB] -> GSI 10 (level, low) -> IRQ 10
cx88[0]/2: found at 0000:00:09.2, rev: 5, irq: 10, latency: 32, mmio: 0xe9000000
cx8802_probe() allocating 1 frontend(s)
cx88/2: cx2388x dvb driver version 0.0.6 loaded
cx88/2: registering cx8802 driver, type: dvb access: shared
cx88[0]/2: subsystem: d460:9022, board: TeVii S460 DVB-S/S2 [card=70]
cx88[0]/2: cx2388x based DVB/ATSC card
DVB: registering new adapter (cx88[0])
DVB: registering adapter 0 frontend 0 (Conexant CX24116/CX24118)...
cx24116_firmware_ondemand: Waiting for firmware upload (dvb-fe-cx24116.fw)...
i2c-adapter i2c-0: firmware: requesting dvb-fe-cx24116.fw
cx24116_firmware_ondemand: Waiting for firmware upload(2)...
cx24116_load_firmware: FW version 1.23.86.1
cx24116_firmware_ondemand: Firmware upload complete
_______________________________________________
linux-dvb mailing list
linux-dvb@linuxtv.org
http://www.linuxtv.org/cgi-bin/mailman/listinfo/linux-dvb
next reply other threads:[~2009-01-03 16:42 UTC|newest]
Thread overview: 33+ messages / expand[flat|nested] mbox.gz Atom feed top
2009-01-03 16:42 Roman Jarosz [this message]
2009-01-03 17:01 ` [linux-dvb] DVB-S Channel searching problem Brice DUBOST
2009-01-03 17:14 ` BOUWSMA Barry
2009-01-03 17:15 ` Roman Jarosz
2009-01-03 17:28 ` Alex Betis
2009-01-03 18:11 ` Roman Jarosz
2009-01-03 18:58 ` Alex Betis
2009-01-03 19:37 ` Gregoire Favre
2009-01-04 8:14 ` Goga777
2009-01-04 8:29 ` hermann pitton
2009-01-04 10:37 ` Gregoire Favre
2009-01-04 16:06 ` hermann pitton
2009-01-04 16:37 ` Gregoire Favre
2009-01-04 17:15 ` hermann pitton
2009-01-04 18:24 ` Gregoire Favre
2009-01-08 2:20 ` hermann pitton
2009-01-04 10:35 ` Gregoire Favre
2009-01-04 10:58 ` Roman Jarosz
2009-01-04 12:42 ` Mika Laitio
2009-01-04 13:11 ` Roman Jarosz
2009-01-04 14:56 ` Goga777
2009-01-04 20:47 ` Roman Jarosz
2009-01-04 21:24 ` Goga777
2009-01-05 17:43 ` Roman Jarosz
2009-01-05 17:58 ` Roman Jarosz
2009-01-05 19:00 ` Goga777
2009-01-06 14:58 ` Mika Laitio
2009-01-03 19:39 ` Roman Jarosz
2009-01-03 20:48 ` Alex Betis
2009-01-03 20:59 ` Roman Jarosz
2009-01-03 21:01 ` Alex Betis
2009-01-04 3:52 ` BOUWSMA Barry
-- strict thread matches above, loose matches on Subject: below --
2009-01-04 19:46 Eduard Huguet
Reply instructions:
You may reply publicly to this message via plain-text email
using any one of the following methods:
* Save the following mbox file, import it into your mail client,
and reply-to-all from there: mbox
Avoid top-posting and favor interleaved quoting:
https://en.wikipedia.org/wiki/Posting_style#Interleaved_style
* Reply using the --to, --cc, and --in-reply-to
switches of git-send-email(1):
git send-email \
--in-reply-to=op.um6wpcvirj95b0@localhost \
--to=roman.jarosz@gmail.com \
--cc=kedgedev@centrum.cz \
--cc=linux-dvb@linuxtv.org \
/path/to/YOUR_REPLY
https://kernel.org/pub/software/scm/git/docs/git-send-email.html
* If your mail client supports setting the In-Reply-To header
via mailto: links, try the mailto: link
Be sure your reply has a Subject: header at the top and a blank line
before the message body.
This is an external index of several public inboxes,
see mirroring instructions on how to clone and mirror
all data and code used by this external index.