Re: [PATCH] EMU10K1.conf

[Takashi Iwai <tiwai@suse.de>]

At Wed, 07 Jan 2004 18:50:42 +0100,
Dominik 'Aeneas' Schnitzer wrote:
> 
> On Mit, 2004-01-07 at 18:07, Takashi Iwai wrote: 
> > the switch of "SB Live Analog/Digital" can be removed if it works for
> > you.  it was set to make sure the center "analog" jack works.
> > (in the recent models, the digital out is shared with the center/lfe
> > jack.)
> > with my emu10k1 board, i don't get any valid signals over
> > center/digital jack unless AC3 is played.  it might depend on the
> > receiver.  perhaps creative has its own protocol?
> > 
> > but, anyway, "Wave Surround" and "Wave Center" don't make sense at
> > all.  they are volumes of duplicated signals.  the volumes of
> > surround/center/lfe channels are different mixer elements.
> 
> Hi,
> 
> I just rechecked everyting. You're right, it's just the "SB Live Analog/Digital"
> switch/lock to "0" in EMU10K1.conf which needs to be removed, to make things work.
> (I'm using a Creative Cambridge SoundWorks DTT3500 receiver, my sblive/emu10k1 card
> has revision 07 (lspci))
> 
> As you pointed out, using the surround/center/lfe/wave volume controls everything can be
> controlled. The WAVE* volume controls-stuff isn't neccessary.
> 
> So basically it boils down to...

ok, then i'll comment out this part on the cvs.

thanks for the confirmation.


Takashi


-------------------------------------------------------
This SF.net email is sponsored by: Perforce Software.
Perforce is the Fast Software Configuration Management System offering
advanced branching capabilities and atomic changes on 50+ platforms.
Free Eval! http://www.perforce.com/perforce/loadprog.html