Re: [PATCH v15 3/3] perf: Add Raspberry Pi 5 (BCM2712) AXI PMU support

[sashiko-bot@kernel.org]

> Extend the Raspberry Pi AXI PMU driver to support the Broadcom BCM2712
> used in the Raspberry Pi 5.
> 
> As on earlier chips, the System monitor is accessed directly via MMIO
> and the VPU monitor via the firmware mailbox. BCM2712 has 6-bit AXI
> master IDs.
> 
> The System bus names in Broadcom's documentation describe the set-top
> box variant of the chip, so they were checked by measurement on C0 and
> D0 boards. RP1 traffic (PCIe2) appears on the port documented as
> BSTM_TOP, SD/eMMC with DMA0 and DMA1 on the one documented as SRC, and
> the WiFi SDIO controller on the one documented as ARB3; these are named
> rp1, sd_dma and sdio_wifi here.
> 
> From BCM2712 D0, three System monitor ports (XPT, PCIE_01 and HVDP) are
> removed and the remaining ones renumbered, with the external PCIe moving
> to the ARGON_TOP port. The bus watchers also match a full AXI ID under a
> mask: 10-bit ID and mask fields on the System monitor, and 6-bit fields
> holding the master ID directly on the VPU monitor. D0 is detected at
> probe by whether the ID mask field is writable, and selects its own bus
> table and filter encoding.
> 
> Co-developed-by: Dom Cobley <popcornmix@gmail.com>
> Signed-off-by: Dom Cobley <popcornmix@gmail.com>
> Signed-off-by: Ian Rogers <irogers@google.com>

Sashiko has reviewed this patch and found no issues.

-- 
Sashiko AI review · https://sashiko.dev/#/patchset/20261102234301.2242242-1-irogers@google.com?part=3