From mboxrd@z Thu Jan 1 00:00:00 1970 From: "Goede, J.W.R. de" Date: Wed, 20 Jun 2007 14:17:08 +0000 Subject: Re: [lm-sensors] initial fintek f71882fg driver, test please Message-Id: List-Id: References: <4676A4D8.5020706@hhs.nl> In-Reply-To: <4676A4D8.5020706@hhs.nl> MIME-Version: 1.0 Content-Type: text/plain; charset="us-ascii" Content-Transfer-Encoding: 7bit To: lm-sensors@vger.kernel.org Walt H wrote: > Compiled and installed fine against a patched 2.6.21 x86_64 kernel . > Looks good so far. I'm displaying sensor values through gkrellm and the > temps and fan values look good. Vcor1 looks high, and the voltage > inputs need tweaks under gkrellm, but I'm mainly interested in temp and > fan values anyway. Appreciate everybody's work on this! Thanks, > > -Walt Thanks for the feedback, on what motherboard did you test? I doubt that vcore 1 is high because vcore usually is connected without a divider, also since if there is a scaling problem, its almost aways a missing divider, not a multiply, I would expect vcore to be to low, not to high. Regards, Hans p.s. Did you try this with the libsensors 3 branch? I would be much oblidged you could, then run sensors and update sensors.conf until things look good and last send the working snesors.conf to te list. Regards, Hans _______________________________________________ lm-sensors mailing list lm-sensors@lm-sensors.org http://lists.lm-sensors.org/mailman/listinfo/lm-sensors